667349
21
Zoom out
Zoom in
Previous page
1/548
Next page
DEEN
19
FRNLITESPTNOSVFIDAPLSLSKHU
0478 201 9906 D - DE
7.1 Radachse und Räder
montieren
Radachse (C) mit
Radanschlägen (D), Schrauben (E)
und Sechskantmuttern (F) am
Radfuß (B) montieren und mit
Kombischlüssel (V) verschrauben
(4 - 6Nm).
Räder (I) auf montierte Radachse
schieben.
Schnellbefestiger (H) mit gewölbter
Seite nach außen auf Radachse
schieben.
Radkappen (J) auf Räder drücken.
7.2 Fahrwerk und
Auswurfschacht montieren
1 Auswurfverlängerung
montieren
Grundgerät (A) wie abgebildet auf ein
ca. 15-20 cm hohes Holzstück legen.
Auswurfverlängerung (O) mit den
Haken (1) von hinten in die
Öffnungen (2) am Grundgerät (A)
einhängen und so nach unten drehen,
dass der vordere Teil des Grundgerätes
exakt in der Öffnung der
Auswurfverlängerung steckt.
Schrauben (U) in die Dome der
Haken (1) eindrehen (1 - 2Nm).
2 Fahrwerk montieren
Vierkantmuttern (K) und Scheiben (L)
in die dafür vorgesehenen
Ausnehmungen am Grundgerät (3)
schieben.
Fahrwerk mit beiden Radfüßen (4) bis
auf Anschlag in die Führungen am
Grundgerät (5) schieben.
Radfuß mit der Biegung (6) in die
Ausnehmung an der
Auswurfverlängerung (7) drücken.
Schrauben (M) mit Scheiben (L) durch
die Öffnungen in den Radfüßen (8)
stecken und mit Kombischlüssel (V)
festziehen (4 - 6Nm).
3 Leiste montieren
Leiste (P) auflegen und Schrauben (R)
eindrehen (1 - 2Nm).
Gehörschutz tragen!
Schutzbrille tragen!
Arbeitshandschuhe tragen!
Verletzungsgefahr!
Nicht auf das Gerät steigen.
Verletzungsgefahr!
Niemals mit Händen, ande-
ren Körperteilen oder
Kleidung in den Einfülltrich-
ter oder den
Auswurfschacht
hineingreifen.
6. Lieferumfang
Pos. Bezeichnung Stk.
A Grundgerät mit
Trichterunterteil
1
B Radfuß 1
C Radachse 1
D Radanschlag 2
E Schraube M6 x 55 2
F Sechskantmutter 2
H Schnellbefestiger 2
I Rad 2
J Radkappe 2
K Vierkantmutter 2
L Scheibe Ø 17 mm 4
M Schraube M6 x 50 2
N Auswurfklappe 1
2
O Auswurfverlängerung 1
P Leiste 1
Q Bolzen 2
R Torxschraube P5 x 20 3
S Trichteroberteil 1
T Sicherheitsschraube 4
U Torxschraube P5 x 10 2
V Kombischlüssel 1
Gebrauchsanleitung 1
7. Gerät betriebsbereit
machen
Schnellbefestiger nur so weit auf
die Radachse schieben, dass sich
die Räder noch leicht drehen.
Schnellbefestiger sind nach der
Demontage nicht
wiederverwendbar.
Pos. Bezeichnung Stk.
3
Die Biegung des Radfußes (6)
muss exakt in den Ausnehmungen
der Auswurfverlängerung (7)
liegen.
4
21


Need help? Post your question in this forum.

Forumrules
1

Forum

viking-ge-150

Reset search

  • Where is the rest locking device on a Viking GE150 shredder please?
    Submitted on 2-4-2022 at 11:49

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking GE 150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking GE 150 in the language / languages: All languages as an attachment in your email.

The manual is 18,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info