813613
46
Zoom out
Zoom in
Previous page
1/52
Next page
Vitoligno 300-C Operating
5790 982 - 02
46
Maintenance
Emptying the Ash Box
Note: Do not isolate the boiler from the power supply at
the mains isolator, as then the ash box would not
be detected by the control unit and no messages
would appear on the control unit display.
Note: If the ash box was emptied without a message
having been displayed on the control unit, reset
the ash fill level at the control unit:
for “Extended menu” “Information”
“Reset data” select “Ash box” “Reset data” 
“Yes”-”No” d to confirm.
CAUTION
Breathing in ash or pellet dust is detrimental to health.
Wear a dust mask to protect your respiratory tract.
1. Switch the boiler off at the control unit with the
“START/STOP” button. Wait until “Buffer drawing”
or “Residual heat utilisation” is shown on the display.
2. Only for pellet supply via vacuum system:
Open left hand front panel (door) A.
3. Open tensioning toggles B by pushing down on the
tensioning toggle clip. Push the ash box a little to the
left.
4. Extract locking bolt C. Push ash partition D back as
far as it will go.
5. Pull out ash box E towards the front.
Note: The telescopic handle can be pulled out to
various lengths.
6. Empty the ash box. For this remove the ash box cover.
7. Remove residues of ash from the base plate.
8. Reseal the ash box with its cover.
9. Proceed in reverse order to re-insert the ash box and
close the boiler.
Note: Observe before closing the boiler that ash
separator D must be opened again.
10. Switch the boiler back on at the control unit with the
“START/STOP” button.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viessmann Vitoligno 300C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viessmann Vitoligno 300C in the language / languages: English as an attachment in your email.

The manual is 1.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viessmann Vitoligno 300C

Viessmann Vitoligno 300C Installation Guide - English - 136 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info