785500

Victron Skylla-TG 48 50 Manual

22
Zoom out
Zoom in
Previous page
1/32
Next page
20
Manual Titan
4.5 Traction battery compensation
If a Traction-battery is connected to the Titan charger the charge
voltages have to be changed. The output voltage has to be raised to
correctly charge the traction-battery. It is possible that the charge
voltages are not correct after activating this compensation. See for
adjusting the charge voltages chapter 4.2.
To set the charger into the traction mode:
Place DIP-switch 3 “trac” to the left.
4.6 Use as a power-supply
The Titan charger can be used as a power supply without the obligation to connect a
battery to the charger output.
To use the charger as a power supply:
Put the charger into the permanent boost-charge mode, see chapter 4.1.
Adjusted the output voltage to the desired voltage, see chapter 4.2.
With the above mentioned procedure the output voltage range is limited. When the full
output voltage range is required please contact your Victron Energy dealer. See chapter 6.3
for details.
4.7 Use of a temperature sensor.
The temperature sensor supplied with the charger can be
connected to the charger by using the 3 meter cable with
stripped and tinned cable ends. This sensor should be
mounted on the battery. The temperature sensor adjusts
the charging voltage according to the battery
temperature.
To connect the temperature sensor:
Disconnect the mains,
Connect the - (black wire) of the temperature sensor
to the “-tmp” connector, see illustration 8.
Connect the + (red wire) of the temperature sensor
to the “+ tmp” connector, see illustration 8.
Switch on the mains.
If the temperature sensor is correctly connected the
“TMP OK” on the printed circuit board led
illuminates. If this led does not illuminate or
flashes, the sensor is not connected correctly.
Illustration 8.
Location of the external conne
tions.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Skylla-TG 48 50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Skylla-TG 48 50 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info