785493
16
Zoom out
Zoom in
Previous page
1/32
Next page
14 Manual Skylla with universal input
3.2 Operation
Located on the front of the Skylla charger are an on/off switch and three rows of
leds, as shown in illustration 5.
The battery charger can be switched on and off with the on/off switch.
The “output voltage” leds indicate the output voltage value.
The “output current” leds indicate the output current value.
The other leds indicates the state of the charger.
The operation sequence:
Switching the charger on with the on/off switch results in the following:
The “on” led will flash for about 2 seconds. In these first 2 seconds the charger
reads all input signals and calculates the necessary output voltage. After 2
seconds the charger will switch on and the “on” led illuminates.
According to the condition of the battery the charger will start in the boost-
charge mode or at float-charge mode. If the battery is not full the “boost” led
illuminates and the charger will start boost-charging the battery.
A dip switch can be used to set the charger so that it will always start charging
in the boost mode, irrespective of the condition of the battery.
When the battery voltage has reached the boost voltage the charger will change
into the equalize-charge mode and the “equalize” led illuminates. This mode will
last for a pre-selectable time of 4, 8 or 12 hours.
After this time the charger will enter the float-charge mode and the “float” led will
illuminate.
After the batteries are charged the Skylla charger does not have to be switched off
and the batteries can stay connected to the battery charger.
Illustration 5. Example of the battery charger front panel.
victron energie
ACCULADER
AUTOMATIL-LADER
BATTERY CHARGER
CHARGEUR AUTOMATIQUE
Output
voltage (V)
Output
current (A)
30
29
28
27
26
25
24
23
112
100
84
70
56
42
28
14
on
boost
equalize
float
failure
on
off
Explosive gasses can occur during charging a lead-acid
battery. Prevent flames and sparks.
Provide adequate ventilation during charging.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Skylla-TG 24 50 (1 1) at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Skylla-TG 24 50 (1 1) in the language / languages: English as an attachment in your email.

The manual is 0.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info