785492
24
Zoom out
Zoom in
Previous page
1/32
Next page
22 Manual Skylla with universal input
The SKC panel:
This panel indicates if the charger is on or off, it indicates the charging mode and it
contains an adjustable potentiometer. Limiting the maximum charging current can
be useful to more accurately charge the batteries according the manufacturers
specifications, or to make sure the shore fuse does not blow.
To connect the panel:
Disconnect the mains.
Connect the on led to the “L_ON” connector.
Connect the boost led to the “ L_BO” connector.
Connect the float led to the “L_FL” connector.
Connect the ground of the panel to the “GND” connector.
Connect current control to the “+ POT” and “-POT” connector.
4.12 Connecting a remote on/off switch
A remote switch can be connected to the charger so the charger can be switched
on and off from a remote location. To operate the switch, first switch the charger
on with the on/off switch located on the charger.
To connect the remote on/off switch:
Disconnect the mains.
Connect the switch in between the “REM” and the “GND” connector.
4.13 Connecting a remote boost switch
A remote switch can be connected to the charger so the charger can be switched
permanently into the boost-charge mode. Due to parallel loads connected to the
battery it is advised to switch the charger into the permanent boost-charging mode
in order not to discharge the battery.
If the switch is closed the charger switches into the permanent boost-charge
mode. If the switch is opened again the charger will automatically go to the float-
charge mode. This in order not to overcharge a battery with charging it to long with
higher charging voltage.
To connect the boost switch:
Disconnect the mains.
Connect one pole of the switch to the “RBOO” connector.
Connect the other pole of the switch to the “GND” connector.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Skylla-TG 24 30 (1 1) at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Skylla-TG 24 30 (1 1) in the language / languages: English as an attachment in your email.

The manual is 0.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info