785497
24
Zoom out
Zoom in
Previous page
1/32
Next page
22
Manual Titan
When dip switch 2 “Watch” is positioned on the right, it is checked upon startup whether
the battery voltage is sufficiently high to enable a start in the float mode. If it is not, the
charger is started in the boost mode as yet.
4.10 Connecting the output voltage alarm
The charger is equipped with a potential free alarm contact (change over type).
If the battery voltage is in between Vmin and Vmax the contact is activated.
(See figure 8, remote connections: NO, NC, COM).
Model Vmin Vmax
24V 23,8 Vdc 33,5 Vdc
48V 47,6 Vdc 67 Vdc
4.11 Connecting remote panels
Victron Energy provides four optional remote panels that can be connected to the charger.
See illustration 8 for the circuit board connector where the remote panels have to be
connected to.
The COV panel:
The maximum charging current of 50A, 80A or 100A, according to the model, can be
limited with an external panel. This panel, the Victron Energy COV panel, contains an
adjustable potentiometer. Limiting the maximum charging current can be useful to meet
the batteries specifications, or to make sure the shore fuse does not blow.
To connect the panel:
Disconnect the mains.
Connect the panel to the “+ pot” and “-pot” connector.
The CMV panel:
This panel indicates the charging mode and possible failures.
To connect the panel:
Disconnect the mains.
Connect the boost led to the “ L_BO” connector.
Connect the equalize led to the “L_EQ” connector.
Connect the float led to the “L_FL” connector.
Connect the failure led to the “L_FA” connector.
Connect the ground of the panel to the “GND” connector.
The CSV panel:
With the CSV panel the charger can be switched on or off. On the panel a green “on” led is
present. To operate the CSV panel you first have to switch the charger on with the on/off
switch located on the front panel of the charger.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron SKYLLA-TG 24 100 3-Phase at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron SKYLLA-TG 24 100 3-Phase in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info