785450
12
Zoom out
Zoom in
Previous page
1/99
Next page
5.6. Calculation of the charging time
A lead battery is about 80% charged at the start of the absorption phase.
The time T until 80% charged can be calculated as follows:
T = Ah / I
In which:
I is the charging current (= current from the charger minus any current due to a
load).
Ah the number of ampere hours that should be charged.
A full absorption period up to 8 hours will be required to charge a battery 100%.
Example:
Charging time to 80% for a fully discharged 220Ah battery when charging it with
a 30A battery charger: T = 220 / 30 = 7.3 hours.
Charging time to 100%: 7.3 + 8 = 15.3 hours.
A Li-ion battery is more than 95% charged at the start of the absorption phase
and will be fully charged after about 30 minutes of absorption charging.
5.7. Use as a power supply
The charger can be used as a power supply (a load is present but no battery is
connected). The supply voltage can be set using Bluetooth or the VE.Direct
interface.
When used as a power supply, only the BULK, ABSORPTION, FLOAT and
STORAGE LEDs will light up and remain lit.
When the charger is set up as a power supply, it will not respond to the remote
on-off.
If the MODE button is pressed while using the charger as a power supply, it will
return to the pre-programmed NORMAL charging algorithm.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Phoenix Smart lader 12 50 (1 1) IP43 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Phoenix Smart lader 12 50 (1 1) IP43 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 0.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info