785448
19
Zoom out
Zoom in
Previous page
1/99
Next page
19
EN NL FR DE ES SV IT
bevelen daarom de reconditioning aan in geval van cyclische
toepassing.
Reconditioning kan worden toegepast op natte accu's om de cellen
‘in evenwicht’ te brengen en om zuurstratificatie te voorkomen.
Sommige fabrikanten van acculaders bevelen impulslading aan om
de sulfatering ongedaan te maken. De meeste accu-experts zijn het
er echter over eens dat er geen overtuigend bewijs is dat impulsladen
beter werkt dan oplading met lage stroom / hoge spanning. Dit wordt
door onze eigen tests ook bevestigd.
4.10. Lithium-ion (LiFePO) accu's
Li-ion accu’s sulfateren niet en hoeven niet regelmatig volledig
geladen te worden.
Maar Li-ion accu’s zijn erg gevoelig voor een te lage- of te hoge
spanning.
Li-ion accu’s zijn om deze reden vaak voorzien van een geïntegreerd
systeem om de cellen te egaliseren (cell balancing) en te
beschermen tegen een te lage spanning (UVP: Under Voltage
Protection).
Belangrijke opmerking:
Probeer NOOIT om een lithium-ion-accu op te laden als de temperatuur
van de accu onder 0°C ligt.3
4.11. Remote on-off
There are three ways to switch on the device:
4. Short the L and H pins (factory default)
5. Pull the H pin to a high level (e.g. the battery plus)
6. Pull the L pin to a low level (e.g. the battery minus)
3 For more information about lithium-ion batteries, see
http://www.victronenergy.com/batteries/lithium-battery-12,8v/
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Phoenix Smart lader 12 30 (1 1) IP43 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Phoenix Smart lader 12 30 (1 1) IP43 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 0.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info