785356

Victron BlueSolar 215Wp mono Manual

12
Zoom out
Zoom in
Previous page
1/80
Next page
8
5.
Electrical Installation
This guide describes some of the most important typical uses as representative examples.
5.1 Grid-connected electrical system
The DC electrical energy generated by photovoltaic systems may also be converted to AC and connected to a utility grid system. As
local utilities’policies on connecting renewable energy systems to their grids vary from region to region.
Consult a qualified system designer or integrator to design such a system. Permits are normally required for installing such a system
and the utility must formally approve and inspect such a system before it can be accepted
5.2 Grounding
The module frame must be properly grounded. The grounding wire must be properly fastened to the module frame to assure good
electrical contact. Use the recommended type, or an equivalent, connector for this wire.
If the support frame is made of metal, the surface of the frame must be electroplated and have excellent conductivity.
We recommend the lay-in lug(Cat. No. GBL4-DBT is recommended by producer) when grounding. First strip 16mm insulating jacket
from the end of the ground wire carefully to avoid nicking or cutting conductors, insert the wire to the feet of the lug (see the picture), and
screw down the slotted screw. Be careful not to damage the wire core. And then tighten up the screw.
Insert ground wire here
Next, assemble the recommended ILSCO grounding lug to the aluminum frame using stainless steel M3 or M5 screw and hardware as
shown below. Note: there are two different size grounding holes, the smaller of which is being phased out. Further, buildup of hardware
for mounting the grounding lug are the same—except for the M3 screw, an added lat washer is mounted directly under the M3 screw
head. The star washer is fitted directly under the grounding lug and makes electrical contact by penetrating the anodized coating of the
aluminum frame, The screw assembly is further fitted with a lat washer, then a split lock washer and finally a nut to secure the entire
assembly, as shown. Recommended torque of M3 or M5 screw assembly is 0.8NM or 1.5 NM.
.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron BlueSolar 215Wp mono at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron BlueSolar 215Wp mono in the language / languages: English, German, Dutch, French, Swedish, Spanish as an attachment in your email.

The manual is 1.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info