785220
12
Zoom out
Zoom in
Previous page
1/63
Next page
10
8. Specifications
Cyrix Li-ion ct
(see Cyrix Li-ion datasheet for more
information)
12/24-120 24/48-120
Continuous current
120A
Connect voltage
From 13,7V to 13,9V and 27,4V to 27,8V
with intelligent trend detection
Disconnect voltage
From 13,2V to 13,4V and 26,4V to 26,8V
with intelligent trend detection
Start Assist
Yes
(The Cyrix remains engaged during 15
seconds after the control input has been
pulled twice to battery minus.)
Cyrix Li-ion load 12/24-120 24/48-120 24/48-120
Please use a Battery Protect instead: much lower power consumption
Cyrix Li-ion Charge 12/24-120 24/48-120
Continuous current
120A
Connect voltage
Engages when voltage on the charger side
exceeds 13,7V to 13,9V and 27,4V to 27,8V
with intelligent trend detection
Engages when voltage on the charger side
exceeds 27,4V to 27,8V and 54,8V to 55,6V with
intelligent trend detection
Disconnect voltage From 13,2V to 13,4V and 26,4V to 26,8V
with intelligent trend detection
From 26,4V to 26,8V and 52,8V to 53,6V
with intelligent trend detection
Charge not active detection The Cyrix disengages every hour and remains open in case of low voltage on the charger side
General 12/24-120 24/48-120
Over voltage disconnect
16V / 32V
Over temperature disconnect
Yes
Current consumption when open
<4mA
Current consumption when closed
<220mA / < 110mA
Operating temperature range
-20 to +50°C
Protection category
IP54
Weight kg (lbs)
0,11 (0.24)
Dimensions h x w x d in mm
(h x w x d in inches)
46 x 46 x 80
(1.8 x 1.8 x 3.2)
VE.Bus BMS
Input voltage range 9 70VDC
Current draw, normal operation 10mA (excluding Load Disconnect current)
Current draw, low cell voltage 2mA
Load Disconnect output
Normally high (output voltage ≈ supply voltage 1V)
Floating when load needs to be disconnected
Source current limit: 2A
Sink current: 0A
Charge Disconnect output
Normally high, (output voltage ≈ supply voltage 1V)
Floating when charger should be disconnected
Source current limit: 10mA
Sink current: 0A
GENERAL
VE.Bus communication port Two RJ45 sockets to connect to all VE.Bus products
Operating temperature -20 to +50°C 0 - 120°F
Humidity Max. 95% (non-condensing)
Protection grade IP20
ENCLOSURE
Material and colour ABS, matt black
Weight kg 0,1
Dimensions (hxwxd) in mm 105 x 78 x 32
STANDARDS
Standards: Safety
Emission
Immunity
Automotive Directive
EN 60950
EN 61000-6-3, EN 55014-1
EN 61000-6-2, EN 61000-6-1, EN 55014-2
EN 50498
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Battery Management System VE.Bus BMS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Battery Management System VE.Bus BMS in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 4.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info