650705
5
Zoom out
Zoom in
Previous page
1/31
Next page
longer than 2,000 hours but at a reduced output. To keep your humidifier operating
at maximum efficiency it is recommended that the UV bulb be replaced after
2,000 hours of use.
REFILL INDICATOR - When illuminated, the water tanks need refilling. See the
section “Filling the Water Tanks”. If still illuminated a few minutes after full tank
is placed on base, reposition water tanks. (Unit will operate with only one water
tank.) Each time you fill tanks, rinse tanks, hot water reservoir and cold water
reservoirs. Clean them according to CLEANING INSTRUCTIONS if minerals or
film are present.
RELATIVE HUMIDITY CONTROL - This controls the humidity level. If moderate
humidity is desired, the control should be turned counterclockwise toward “ ”;
and if higher humidity is desired, clockwise toward “ ”. NOTE: When you
unpack your humidifier, you may find it has droplets of water on some surfaces.
This is normal as every unit is tested prior to shipping. Carefully unpack humidifier
and remove all packing material.
OPERATING INSTRUCTIONS
1. Place the base of the unit on a firm, flat, level and water resistant surface.
2. Fill the water tanks according to the instructions below and place on
humidifier base.
3. Plug the power cord firmly and completely into the wall outlet.
4. Push the power switch to the ON position (Lights may flicker momentarily).
Then turn the relative humidity knob clockwise until you hear a faint click. It will
be normal for the humidifier to take a few minutes to warm up and begin to mist.
5. When the water tanks are empty, (after approximately 24 hours running time),
the “REFILL WHEN LIT” lamp will go on, and the unit will stop heating. Refer
to the “FILLING THE WATER TANKS” section.
6. Whenever the water falls below the level of the float switch during operation,
the heating element will shut off and stop heating, and the REFILL indicator
will light.
7. The unit will operate as long as there is water in either tank and unit will
operate with either one or both tanks.
FILLING THE WATER TANKS
1. Before filling the water tanks, push the POWER switch to the “OFF” position
and unplug unit. Refer to CLEANING INSTRUCTIONS.
2. Remove water tanks from base, turn each tank upside down and remove tank
cap by turning counterclockwise. Fill tank with clean cold tap water. Replace
the tank cap by turning clockwise. Tighten firmly.
3. Carefully pick up tank, since it will be heavy when full, and slippery if wet.
4. Place water tanks on base. Make sure tanks are properly placed, otherwise,
the humidifier will not work correctly.
USING THE MEDICINE CUP
In order to add Vicks VapoSteam or Kaz Inhalant to the “mist” output:
1. Push the POWER switch to the “OFF” position and allow the Top Housing to cool.
2. Carefully add liquid medicine to medicine cup. DO NOT fill the cup more than
half full.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vicks V790 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vicks V790 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info