484572
31
Zoom out
Zoom in
Previous page
1/74
Next page
25
NOTE: Glance under the machine occasionally for signs of water leakage. If water shows under the
machine, first unplug the power cord and then turn the machine off before assessing the situation.
If the source of the leak cannot be determined and eliminated, contact your reseller for assistance.
Damage caused by water leaks is not covered by the warranty.
WARNING: Water leaking from the machine may indicate a hazardous situation exists. Discontinue
use until the cause is determined are mitigated.
Brew Boiler Warm Up
WARNING: In normal use the group will become very hot. Parts of the metal can be over 200 F.
(93 c.). Touching the group, even briefly, can cause serious burns. Use great caution around all hot
parts of this machine!
When water came from the brew boiler it signified that the pump had done its job and the brew boiler is
filled to capacity. Allow the machine to heat up. The temperature of the brew boiler is indicated on the PID’s
display, and that temperature should be increasing by now. When the PID display reads around 200 F. (around
93 c.), do another check for leaks, and if everything looks dry, lift the brew lever to the brew position and run
about 16 ounces through the group. Catch some of the water in a suitable container and check the water for
any unnatural odors. Repeat the flushing of water through the group until any odors are gone.
NOTE: It is necessary to flush out the brew boiler to remove any contaminates or bad tastes and
smells from the manufacturing process that may linger. This will take approximately 16 ounces (.5
liters), or maybe a bit more. Be sure to check the reservoir’s water level.
WARNING: In operation the water that comes from the brew group can be over 200 F. (93 c.). Seri-
ous burns can result from contact with this water. Use caution!
Steam Boiler
Now that the brew boiler is operating correctly and has been flushed clean, it is time to do much the same
for the steam boiler. Check that both the steam and hot water valves are closed, check the water level in the
reservoir, and turn the power switch to “Position II” for the first time. You have now energized the steam
boiler’s heating element which supplies steam to the steam valve (on the left front of the machine) and hot
water to the hot water valve (to the valve on the right front of the machine)
NOTE: Remember to check the water level of the reservoir.
Keep watch as the steam boiler warms up. It takes about five to ten minutes. You
may notice some sounds during this time as the water in the steam boiler heats. A bit
of hissing early until the vacuum relief valve closes is normal. This steam and pos-
sibly a small amount of water is vented into the drip tray through the metal tube on
the left side of the back of the tray.
While the heating element in the steam boiler is energized, the indicator on the
far left side of the front panel, next to the steam boiler’s pressure gauge, will be il-
luminated. Watch the pressure gauge, and after some preheating time you will see the
gauge begin to rise indicating that pressure in the boiler is increasing.
CAUTION: Keep an eye on the tip of the steam wand and the outlet of the hot
water wand. If they begin to dribble or hiss, tighten the appropriate valve
just tight enough to ensure that the flow of steam or hot water stops.
WARNING: The valve bodies as well as the steam wand and hot water wand
can be hot enough to cause serious burns. Get into the habit of assuming
that they are hot and handle them appropriately.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vibiemme Vibiemme Double Domobar version 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vibiemme Vibiemme Double Domobar version 3 in the language / languages: English as an attachment in your email.

The manual is 7,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vibiemme Vibiemme Double Domobar version 3

Vibiemme Vibiemme Double Domobar version 3 Additional guide - English - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info