484572

Vibiemme Vibiemme Double Domobar version 3 Manual

28
Zoom out
Zoom in
Previous page
1/74
Next page
22
Final Setup And Initial Startup - Reservoir
NOTE: This chapter will take you through setting up the machine in order to use water from the
internal reservoir. Even if you plan on plumbing the machine, it is important to first verify that
the reservoir option operates properly. You will eventually need to use the reservoir to descale
the machine, and if for no other reason, we would like you to verify that the reservoir option is
working properly while the machine is still under warranty.
WARNING: Until told to do so later in this section, DO NOT plug the machine’s power cord in!
Reservoir Water Supply
To prepare the machine to use the reservoir, the gray lever on
the bottom of the machine must be turned so that it points to the
RIGHT side of the machine (when facing the machine from the
front). That is, pointing to the same side as the hot water tap.
CAUTION: If this lever is in the wrong position the pump
can be run dry and damaged. Damage from operating the
machine with insufficient water supply is not covered by
the warranty.
The next step is to lift off the top cover of the machine using the two handles, lift the hose out of the
reservoir, and remove the water reservoir from the machine. Wash it using a small amount of mild detergent
and a soft sponge, rinse thoroughly to remove all traces of soap, and dry the reservoir. Never use any abrasive
scrubbing pads or products which might scratch the plastic of the reservoir.
Looking down into where the reservoir normally resides, you will see its platform. The vertical movement
of this platform operates a microswitch. When the water level gets low, the reservoir weighs less, and so the
platform is lifted by the action of the springs upon which it rests. Before the reservoir runs dry, a switch under
the platform will shut down the machine and the low water lamp will be illuminated. If that happens, neither
the pump nor the heating elements will operate.
NOTE: The platform is captured in the machine and is not removable.
Before using the reservoir it is best to remove the screw that is located in the center of the platform. If left
in place it can vibrate to a tighter position and defeat the water level
safety switch. If that happens the machine can run low on water and
be damaged.
CAUTION: Damage to the machine from running low on water
is not covered by the warranty.
After removing the screw it is important to check the operation
of the water level safety switch. To verify that the switch is working
properly, place the empty reservoir back into the machine and slowly
press the reservoir downward. When it descends about 1/2 inch (1 to
2cm) you should hear a click sound. That is the switch. Now release
the reservoir slowly, and once again there should be another click.
If those “clicks” do not occur contact your reseller for technical
assistance.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vibiemme Vibiemme Double Domobar version 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vibiemme Vibiemme Double Domobar version 3 in the language / languages: English as an attachment in your email.

The manual is 7,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vibiemme Vibiemme Double Domobar version 3

Vibiemme Vibiemme Double Domobar version 3 Additional guide - English - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info