474306
8
Zoom out
Zoom in
Previous page
1/26
Next page
6
EN
5. Route the sensor wire up the fork blade and secure it with the tape. Wrap excess wire around the front brake cable housing,
leaving enough slack to attach the Mounting Bracket easily to the handlebar and allow for movement of the bar and stem.
CAUTION: WHEN INSTALLING THE SPEED SENSOR ON A SUSPENSION FORK, MAKE SURE THAT THE FORK
IS FULLY EXTENDED TO ENSURE THERE IS ENOUGH WIRE TO REACH THE MOUNTING BRACKET PROPERLY.
EXCESS SENSOR WIRE SHOULD BE TAPED DOWN OR WRAPPED AROUND THE BRAKE CABLE HOUSING FOR
SAFETY.
6. Snug the Zip-Tie down to hold the sensor in its fi nal position.
7. Remove the Spacer and verify that the magnet and sensor spacing stayed the same. (see Fig. 5)
Fig. 5
Wired Speed
Sensor
SPD
Magnet
Important
Do not use a Zip-Tie tightening tool or a third hand tool when doing the fi nal tensioning of the Zip-Ties. This can
tear and damage the sensor.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VETTA VL110A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VETTA VL110A in the language / languages: English as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of VETTA VL110A

VETTA VL110A User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info