Manual VETTA V100 WL2X (page 28 of 44) (English)

538687

Zoom out

Zoom in

1/44

Step 3:

Step 4:

Step 5:

Step 6:

Step 7:

alignment mark on the sensor. (Fig. 1, 2)

Attach the alignment setup spacer to the magnet

temporarily. (Fig. 3)

Slide and rotate the sensor until the alignment mark just

touches the spacer tip on the magnet. (Fig. 4)

Route the sensor wire up the fork blade and secure it

with the tape. Wrap excess wire around the front brake

cable housing, leaving enough slack to attach the

mounting bracket easily to the handlebar and allow for

movement of the bar and stem. CAUTION: When

installing the speed sensor on a suspension fork,

make sure that the fork is fully extended to ensure

there is enough wire to reach the mounting bracket

properly. Excess sensor wire should be taped down or

wrapped around the brake cable housing for safety.

Snug the zip tie down to hold the sensor in its final

position.

Remove the spacer and verify that the magnet and

sensor spacing stayed the same. (Fig. 5)

Note: Do not use a zip-tie tightening tool or a third hand tool

when doing the final tensioning of the zip-ties. This can tear and

damage the sensor or transmitter.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of VETTA V100 WL2X in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

VETTA V100 WL2X Manual

Product: