474331
7
Zoom out
Zoom in
Previous page
1/10
Next page
MAGNET, SENSOR AND BRACKET INSTALLATION
We recommend that you install your C-16 in the following manner, starting with
the sensor unit on the fork and working up to the mounting bracket on the handlebar.
STEP 1
Mount the new Vetta universal S-2 sensor (pat. pend.) loosely (so that you can
slide it around) to the fork blade using the zip-tie provided. The sensor can be
mounted at any point along the fork, however, we recommend a position on the
back side and near the top of the left fork blade. This will protect the sensor from
being hit by rocks, trees and other objects.
STEP 2
Again, loosely install the sensor magnet to one of the spokes on the left side of
the front wheel. Adjust the magnet and sensor position by sliding both pieces
around until you get the sensor as high on the fork blade as possible while still
maintaining the necessary magnet to sensor spacing (1-2mm).
NOTE: The magnet
should pass within 1-2mm of the sensor, and the top of the magnet should be no
higher than the top of the small arrow molded into the face of the sensor.
Sensor
Zip-Tie
Alignment
Arrow
Fork Leg
Wheel
Magnet
1-2mm
Wiring Diagram
!
!
STEP 3
Route the sensor wire up the back of the fork securing with electrical tape.
CAUTION Do not use zip-ties to secure the sensor wire to the bike as this
may result in cut or broken wires.
CAUTION Be sure to leave enough slack in the wire to allow for the steering
motion of the bike and the action of the suspension fork, if you have one.
STEP 4
Carefully wrap the excess sensor wire around the front brake cable housing,
securing with electrical tape when necessary. When you are finished, you
should have just enough slack for the computer mounting shoe to reach the
handlebar.
Check to make sure that all of the excess sensor wire is either taped down or
wrapped around the brake cable so that nothing can catch on it while you are riding.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VETTA C16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VETTA C16 in the language / languages: English as an attachment in your email.

The manual is 0,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of VETTA C16

VETTA C16 User Manual - German - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info