574308

Vertex Standard EVX-530 Series Manual

7
Zoom out
Zoom in
Previous page
1/52
Next page
EVX-530 SEriES OpErating Manual
5
WarnIng! Ic rss general requIrement
englIsh
r
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and max-
imum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
r
This radio transmitter (identify the device by certification
number, or model number if Category II) has been approved
by Industry Canada to operate with the antenna types listed
at the right with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna
types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited
for use with this device.
When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from
your mouth and keep the antenna at least 2 inches (5 cm) away from your head and body.
The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-
Talk congurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than
50% of the time can cause IC RSS General Requirement to be exceeded. To keep the Body Worn congu-
ration with the Vertex Standard CLIP-20 belt-clip, reduce the maximum operating duty cycle still more.
The radio is transmitting when the red LED on the top of the radio is illuminated. You can cause the ra-
dio to transmit by pressing the P-T-T button.
SAR compliance for body-worn use was only demonstrated for the specic belt-clip (CLIP-20). Other
body-worn accessories or congurations may NOT comply with the IC RSS General Requirement and
should be avoided.
When operate the radio with the Vertex Standard CLIP-20 belt-clip, make the transmission time as short
as possible, to keep the Body Worn conguration.
Vhf model uhf model
ATV-16A:2.15dBi,50-ohm ATU-16A:2.15dBi,50-ohm
ATV-16B:2.15dBi,50-ohm ATU-16B:2.15dBi,50-ohm
ATV-16C:2.15dBi,50-ohm ATU-16C:2.15dBi,50-ohm
ATV-16XL:2.15dBi,50-ohm ATU-16F:2.15dBi,50-ohm
ATU-16BS:2.15dBi,50-ohm
ATU-16DC:2.15dBi,50-ohm
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vertex Standard EVX-530 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vertex Standard EVX-530 Series in the language / languages: English as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info