815507

Vermont Castings Radiance Series Manual

29
Zoom out
Zoom in
Previous page
1/56
Next page
2929 3-90-30007498Vermont Castings • Radiance RADVT Installation Manual_R32 • 10/23
1. STOP! Read the safety information above.
2. Turn o󰀨 all electrical power to the stove.
3. Turn the On/O󰀨 switch to “OFF" position, set the remote
to OFF or set thermostat to lowest level.
4. Open control access panel.
5. Push in gas control knob slightly and turn clockwise
to “OFF".
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This heater has a pilot which must be lit manually. When
lighting the pilot follow these instructions exactly.
B. BEFORE LIGHTING smell all around the heater area
for gas. Be sure to smell next to the oor because some
gas is heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any stove
• Do not touch any electric switch
• Do not use any phone in your building
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the Fire
Department
LIGHTINGANDOPERATINGINSTRUCTIONSFORRADVTMODELS(MILLIVOLTONLY)
Lighting Instructions
3/8" - 1/2"
FP1068
Lighting instructions
Pilots
SIT NOVA
PILOT
ON
OFF
ON
P
I
L
O
T
O
F
F
O
F
F
FP1067
lighting instruction
knobs
3/9/01 djt
5
4
3
2
1
O
F
F
P
i
l
o
t
WARNING:Ifyoudonotfollowtheseinstructionsexactly,areorexplosion
may result causing property damage, personal injury or loss of life.
1. Turn the On/O󰀨 switch to O󰀨 position or set the thermostat
to lowest setting.
2. Turn o󰀨 all electric power to the stove if service is to be
performed.
3. Open control access panel.
4. Push in gas control knob slightly and turn clockwise
to “OFF". Do not force.
5. Close control access panel.
• If knob does not pop up when released, stop and
immediately call your service technician or gas supplier.
• If after several tries, the pilot will not stay lit, turn the gas
control knob to “OFF" and call your service technician
or gas supplier.
11. Replace glass door.
12. Turn gas control knob to “ON" position.
13. Turn the On/Off switch to “ON" position or set
thermostat to desired setting.
14. Turn on all electrical power to the stove.
10. Push the control knob all the way in and hold. Immediately
light the pilot by repeatedly depressing the piezo spark
ignitor until a ame appears. Continue to hold the
control knob in for about one (1) minute after the pilot
is lit. Release knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 5 through 8.
6. Wait ve (5) minutes to clear out any gas. Then smell
for gas, including near the oor. If you smell gas, STOP!
Follow “B" in the safety information above. If you do not
smell gas, go to the next step.
7. Remove glass door before lighting pilot. (See Glass
Frame Removal section).
8. Visibly locate pilot by the main burner.
9. Turn knob on gas control counter-clockwise to
“PILOT".
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, do not try to repair it, call a qualied service
technician. Applying force or any attempted repair may
result in a re or explosion.
D. Do not use this stove if any part has been under water.
Immediately call a qualied service technician to inspect
the heater and to replace any part of the control system
and any gas control which has been under water.
ToTurnO󰀨GasToHeater
F. Lighting and Operating Instructions
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermont Castings Radiance Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermont Castings Radiance Series in the language / languages: English as an attachment in your email.

The manual is 6.69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vermont Castings Radiance Series

Vermont Castings Radiance Series User Manual - French - 46 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info