815505

Vermont Castings Montpelier II Manual

21
Zoom out
Zoom in
Previous page
1/32
Next page
21 04/237101-803R
A. Glass B. Firebrick
Service Part: SRV7095-022
Replace the rebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
Inspect the rebrick after each ash removal.
The rebox is lined with high quality rebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a re on the rebox oor. Do not operate
appliance without rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from appliance and vacuum rebox.
2. Remove new brick set from box and lay out to
diagram shown.
3. Lay bottom bricks in appliance.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of rebox and push the bottom of the brick until it is ush
with the side of the appliance.
NOTE: Replace with 5mm ceramic glass only.
Service Part: SRV7095-054
1. Ensure that the re is out and the appliance is cool to the
touch.
2. Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3. Remove the door with the broken glass by lifting the door
up and o󰀨 of the hinges.
4. Lay door face down on a table or counter making sure
the handle hangs over the edge so the door lays at, on
a soft surface.
5. Remove the screws from each glass retainer and remove
the glass. (If screws are di󰀩cult to remove, soak with
penetrating oil rst).
6. Center the glass with edges evenly overlapping the
opening in the door, (i.e. same space top and bottom,
left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure.
2
3
4 45
66
1
1
1 1 1 1 1
1
1
1
11
1
Figure 21.1
1.31
5.81
6
Figure 21.2
Placement Dimensions Qty Required
19” x 4.5” x 1.25” 13
24.5” x 4.5” x 1.25” 1
35.75” x 4.5” x 1.25” 1
49” x 3” x 1.25” 2
57” x 3” x 1.25” 1
69” x 4.5” x 1.25” w/Angle 2
Table 21.1
NOTE: DO NOT OVER TIGHTEN RETAINERS - can
cause glass to break.
5 5 Service Parts Replacement
9. Replace the door on the appliance.
Vermont Castings appliances are equipped with ceramic
super heat-resistant glass, which can only be broken by
impact or misuse.
Injury Risk.
• Use only glass specied in manual.
• DO NOT REPLACE with any other material.
WARNING
Handle glass assembly with care.
When cleaning glass:
Glass
Assembly
CAUTION
• Avoid striking, scratching or slamming glass.
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white lm.
• Use commercial oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will
permanently stain glass on next ring.
Refer to maintenance instructions.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermont Castings Montpelier II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermont Castings Montpelier II in the language / languages: English as an attachment in your email.

The manual is 10.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vermont Castings Montpelier II

Vermont Castings Montpelier II User Manual - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info