815503
16
Zoom out
Zoom in
Previous page
1/28
Next page
Vermont Castings • Intrepid FlexBurn® Owner’s Manual_R22 • 2018 - ___ • 08/23 163-90-30007345C
Keep Your Stove Looking New and Working Its Best
Letthereinthestovegooutandallowthestovetocool
completely before beginning any maintenance procedure.
Care of the Cast Iron Surface
Anoccasionaldustingwithadryragwillkeepthepainted
castironofyourIntrepidFlexBurn®lookingnew.
Thestove’spaintcanbetouchedupasneeded.First,mask
the areas, such as enameled parts, glass, or handles, around
the spot to be painted. Clean the spot with a wire brush.
Removethegriddleandsetitaside.Itisnormalforthegriddle
todarkenafteruse.Youcancleanitwithane-bristlewire
brush, or steel wool.
Then, touch up the stove with high temperature stove paint.
Applythepaintsparingly;twolightcoatsofpaintarebetter
than a single heavy one.
Care of the Porcelain Enamel Surface
Useadryorslightlydampragorsoftbrushtoremovespills
orstains.Fordi󰀩cultjobsthatrequireacleaningagent,use
onlyakitchenappliancecleanerorpolishrecommendedfor
use on enamel surfaces.
Ifporcelainenamelbecomeschippedor scratchedduring
use,apply“enamelepoxy”tothedamagedareaandallow
todry.Oncetheepoxyhasdried,sandtheareatoblendwith
surroundingareaandapplyappropriatecolortouch-uppaint.
Allow to dry completely before operating stove.
A. Cleaning & Replacement of the Glass
Mostofthecarbondepositsontheglasswillburno󰀨during
hotres.
However, the ash residue that accumulates on the glass
surface should be removed regularly to prevent etching. To
clean the glass, follow this procedure:
• Besuretheglassiscompletelycool.DONOTcleanglass
while hot.
Clean the glass with water or a cleaner made especially for
thispurpose.Donotuseabrasivecleaners.Usecleaning
agentssparinglyandbesuretokeepthemo󰀨theouter
surfaces of the stove.
• Rinsetheglassthoroughly.
Dry the glass completely. Figure 3.1-Explodedviewoftheglassassemblyfortherightdoor.
Retainer
Clips (3)
Glass Panel
Gasket
RightDoor
Replace Broken Glass Immediately
Do not operate your stove if the glass in the doors is damaged.
Ifyouneedtoreplacetheglass,useonlythehightemperature
5mmceramicglasssuppliedbyVermontCastings.Donot
use substitutes.
Removing the Glass
1. Removetherightandleftdoorassembliesbyraisingthe
door until the lower and upper hinge pin clears its holes.
Placethedoorsfacedownonapaddedworksurface.Be
especially careful with enameled doors.
2. Removethescrewsthatholdtheglassretainerclipsin
place, and remove the clips.
3. Carefullyliftthebrokenglasspanelfromthedoor.
Installing the Glass
Checkthegasketaroundthewindow;itshouldbesoftand
resilient so that the glass will seal properly against the door.
Replacethegasketifithashardenedorifitiscompressed.
1. Centertheglassonthegasket.
2. Securetheglassonboth doors with the retainerclips.
Tighten all screws. (Figure 3.1)
3. Replacethedoorsonthestove.
4. Openandclosethedoorstocheckthattheytandwork
properly. Adjust as necessary.
3 3 Maintenance
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermont Castings Intrepid FlexBurn at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermont Castings Intrepid FlexBurn in the language / languages: English as an attachment in your email.

The manual is 10.81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vermont Castings Intrepid FlexBurn

Vermont Castings Intrepid FlexBurn User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info