L Make sure that the headrest is inserted at least to the marked position to be fixed securely and
reliably.
The depth of the headrest can be adjusted by slightly loosening the adjusting screws to allow
movement of the sprocket gears. Then you can adjust the headrest to your needs and secure it by
retightening the adjusting screws. If the adjusted position is not satisfactory, you can repeat this
process.
L Ensure that the back of your head is supported when relaxed in an upright sitting position.
L Before using the headrest all fixing screws must be tightened properly, since injuries might
result when it slips downwards unintentionally.
You can secure your head against tipping sideways by lightly pressing the side panels of the headrest
inwards and to the front.
L Do not exert too much pressure on the side panels otherwise bruising may result.
L Do not clap the side panels together violently, otherwise they might break off, causing possible
injury as well as loss of function.
Structural alterations to the headrest would void any warranty.
LEG SUPPORTS
If the leg supports supplied with the wheelchair do not meet your requirements, you could consider leg
supports with adjustable height. Because the footrest attachment is standardised, it can be assembled
in the same way as described in the section on foot supports.
Kindly consult your specialist dealer if you have questions about other footrest systems; he shall gladly
advise you about the indication and function of our available foot supports.
PERSONAL SAFETY SYSTEM (B58)
For your safety we offer you a standardised safety belt which is equipped with a snap-on fastener, like
those mounted in cars and vans. This can be fixed by means of bolts inserted in the bolt holes on both
sides of the seat frame next to the backframe attachments. To ensure proper fixing, self-locking
("nylock") nuts should be used.
If the belt has been dismantled, only new genuine nuts provided by the manufacturer should be used
for re-attachment.
L To ensure the validity of the warranty, entrust this work to your specialist dealer.
L Before using the seatbelt, make sure that all screws are properly tightened.
Please consult your specialist dealer if you require other safety belt systems. He/she shall gladly
assist you further.
BODY SUPPORTS (L04)
If your upper body requires stronger bracing than that
provided by the standard backrest, we offer a lateral
support system which can be mounted on the
backrest. The guiding rail is mounted vertically about
6 cm behind the backrest to one side. The screw
threads set in the back, can be used for this purpose
(older models can be upgraded by using wood
screws). The supporting rods are inserted from the
rear and secured by the two Phillips screws. When
adjusting the height and depth of the supports, slightly
loosen the Philips screws (1) and position the
supports to your liking. Then retighten the Philips
screws (1).
To adjust the depth of the supports, you can loosen screws (2) and set them to the desired depth.
