797876
21
Zoom out
Zoom in
Previous page
1/200
Next page
Carpo 2 SE, Carpo 2 XD SE
2021-05
Using your scooter
17
EN
NL
3.8 Charging the batteries
Risk of injuries and damage due to fire
Only use the battery charger delivered with the scooter
. The use of any other charger may be
dangerous (fire hazard).
The battery charger is only intended to charge the batteries delivered with the scooter
, not to
charge any other batteries.
Do not adapt any of the delivered parts, like cables, plugs or battery charger. Never open or
change the battery or the connection points.
Protect the battery and battery charger against flames, high and low temperatures (see chapter
6), moisture, sunshine, severe shocks (for example dropping). Do
NOT use the battery if this
has been the case.
Charge the battery with the battery charger, indoors, in a well-
ventilated area, out of children's
reach.
First read the user instruction of the applied battery charger before charging the
scooter’s
battery
. For more information, contact your specialist dealer or consult our website
http://www.vermeiren.com/
Risk of damage
Battery self-discharge and the quiescent current of the connected users will drain the
battery
charge slowly. The battery may be irreversibly damaged if the battery is fully discharged.
Therefore, make sure that the battery is charged on time:
o With intensive use (long distances, daily use): Immediately recharge after use.
o With
average use (short distances, daily or a few times a week): Charge when battery
indicator shows 50% discharge.
o With little use or storage: Charge once a week.
Read the storage and maintenance instructions in chapter 4 and technical
details in chapter 6.
Only disconnect the battery charger when the battery is fully charged, see
the following symbols on the charger.
Do not charge batteries below 0°C. Move the battery to a warmer place
and start charging.
Keep the connection point for the battery charger free of dust and other contamination.
I
n case of any problems whereby the battery cannot be charged according to following
instructions, please contact your specialist dealer.
For instructions on how to change the batteries, see the installation manual.
It is recommended to unplug the battery charger from the mains when not in use. This is
to prevent unnecessary energy consumption.
If appliances stay plugged into the USB port
while charging the electronic wheelchair, the
battery will never charge fully. T
herefore, unplug all appliances from the USB port before
charging the wheelchair.
The light emitting diode (LEDs) in the steering unit indicates the remaining capacity of your
batteries. If the battery charger is turned on and no LED's are lit, check the fuse. If the red LED
does not illuminate, the charger is defective.Consult your specialist dealer.
1. Switch the scooter OFF and remove the key.
2. FIRST connect the battery charger to a 230V AC power socket.
3. If applicable, open the cover of the charging point on the scooter.
4. Connect the charger.
5. Refer to the battery-charger manual for the explication of the indicators on the charger.
6. When the battery is fully loaded, disconnect the scooter from the charger.
7. Switch the scooter ON and check if all lights of the battery status indicator are ON.
WARNING
CAUTION
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermeiren Carpo 2 SE - 2021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermeiren Carpo 2 SE - 2021 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 15.09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info