806445
35
Zoom out
Zoom in
Previous page
1/100
Next page
35
EN
1. Unpack
Remove the packaging materials and dispose of them properly. Check that the appliance
is not damaged. Do not connect the appliance if it is damaged. Report any damage
immediately to the salesperson via customer service. In that case, keep the packaging.
2. Location
The location where you place your appliance should be well ventilated and the air should
not be too hot. Do not place the appliance near a heat source, such as a stove or boiler, and
avoid direct sunlight, so as to guarantee the cooling effect and save on energy consumption.
Do not place the appliance in a damp place so that it cannot rust and there is no leakage
current.
3. Installation of the appliance
This appliance is not intended for use as a built-in appliance.
To reverse the direction in which the door opens, go to section 3.1.
During operation, the appliance emits heat to the environment.
Therefore there must be at least 3 cm clearance on the top, at least 10
cm on both sides and at least 5 cm on the back of the fridge (see also
page 33).
Use the front adjusting legs to level the appliance. If the appliance is
not level, it may affect the performance of the gasket seal or even lead
to a failure of your appliance.
It must be possible to disconnect the appliance from the mains power
supply. The plug must therefore be easily accessible after installation.
Place the appliance on a rm and at surface (oor) so that it is
stable, otherwise vibrations and noise may occur.
When placing the appliance on oor coverings such as carpets,
straw mats or polyvinyl chloride (PVC), place a solid sheet or
cover under the appliance to prevent colour change due to heat
dissipation.
Before installing the appliance, carefully review the safety information (section 1).
3. INSTALLATION
When the appliance is installed, check that the earthing wire and the circuit breaker work
normally.
If vibration noise occurs because the freezer is positioned against the wall or if the wall
becomes black due to air circulation around the compressor, you should place the device
away from the wall.
Warning!
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Veripart VPVR701 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Veripart VPVR701 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info