806411
27
Zoom out
Zoom in
Previous page
1/53
Next page
52 53
4. Move the cover left at the top of the door to the
right at the top of the door. Then lift the door and
place it on a soft surface to prevent scratches.
5. Loosen the pin on the bottom hinge, turn the hinge bracket around and
screw the pin back in.
6. Mount the bracket on the lower hinge pin.
Screw on both levelling feet.
7. Place the door on the bottom hinge again.
Make sure that the door is aligned horizontally
and vertically so that the seals on all sides t
tightly onto the door before permanently
mounting the top hinge.
8. Place the top left hinge on top of the
appliance and screw tight.
9. Use a spanner to tighten it, if necessary.
10. Replace the hinge cover and the screw.
11. After tightening the hinges, check that the
door seals are in good alignment with the
refrigerator casing throughout. If this is not the
case, the rubber seal can easily be pulled off,
turned 180° and then pressed back into
the rebate.
12. Checking and cleaning the rubber seals
a. Method 1: Clamp a thin piece of paper in
various places. The paper should be difcult to pull out in all
these places.
b. Method 2: Place a torch on a shelf inside the appliance and aim the
light at the seal; close the door and see if you can see any light.
If the seal is uneven, heat the seal rubber in the affected areas with a
hairdryer and shape them with your ngers.
Keep the door seals clean. Sticky food and drink can make the seals stick to
the cabinet and then tear when you open the door. Clean the seal with a mild
detergent and warm water. After cleaning, rinse well and dry. Caution! Do
not switch on the appliance until the door seals are completely dry.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Veripart VPKK143W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Veripart VPKK143W in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info