566993
2
Zoom out
Zoom in
Previous page
1/6
Next page
2 VELUX
1
ø 3 mm
ø 3 mm
1
2
3 4
25 mm
15 mm
ENGLISH: Fitting can only take place from the
outside: Place blind in the centre of the window
as shown. The top hole must be 25 mm from top
cover edge. Mark holes on both sides of blind with
a pencil (1). Start holes with a centre punch (2)
and drill through cover using a ø 3 mm drill. Drilling
depth = 15 mm (3). Place sealant supplied on
exterior of covers. Fix awning blind with screws
supplied (4).
DEUTSCH: Montage kann nur von der Außen-
seite – auf dem Dach – erfolgen: Markise wie
dargestellt mittig am Fenster montieren. Das obere
Loch muss 25 mm von der Kante des Abdeckkastens
entfernt sein: An beiden Seiten die Bohrlöcher für
die Markise anzeichnen (1), Löcher mit einem Kör-
ner vorstechen (2) und mit einem Ø 3 mm Bohrer
durch die Abdeckbleche hindurch aufbohren. Bohr-
tiefe = 15 mm (3). Dichtungen auf den Abdeckble-
chen anbringen und Markise mit den mitgelieferten
Schrauben befestigen (4).
FRANÇAIS : Partie de l'installation qui ne peut
se faire que de l'extérieur : Placer le store à
l'extérieur bien axé sur la fenêtre. Le trou supérieur
doit se trouver à 25 mm du bord du profilé haut.
Marquer au crayon les trous de vis de chaque côté
(1). Prépercer les trous à l'aide d'un poinçon (2)
et
percer le capot avec un foret de Ø 3 mm. Pro-
fondeur
à percer = 15 mm (3). Placer les rondelles
d'étanchéité sur le capot de la fenêtre du côté
extérieur. Fixer le store à l'aide des vis fournies (4).
DANSK: Montering kan kun ske udefra: Markisen
centreres over vinduet som vist. Det øverste hul
skal være 25 mm fra topkassens kant.
Huller
markeres i begge sider af markisen med
blyant (1).
Huller markeres med en kørner (2),
og der bores
gennem beklædningen med et Ø 3 mm bor.
Bore-
dybde = 15 mm (3). Medleveret pakning anbringes
på den udvendige side af beklædningen.
Markisen
skrues fast med de medleverede skruer (4).
NEDERLANDS: Bevestiging kan enkel vanaf de
buitenzijde: Plaats de buitenzonwering in het mid-
den van het combinatie-element zoals aangegeven.
Het bovenste bevestigingsgat dient zich 25 mm
vanaf de afdekkap te bevinden. Markeer de beves-
tigingsgaten op de afdeklijsten met een potlood (1).
Prik de gaten voor met een priem (2) en boor door
de afdeklijst met een ø 3 mm boor.
Boordiepte = 15
mm (3). Plaats de afdichtingsringen
op de lijsten aan
de buiten zijde. Bevestig de buitenzonwering met
de meegeleverde schroeven (4).
ITALIANO: Montaggio da effettuarsi solo dal-
l'esterno: Posizionare la tenda al centro della finestra
come illustrato. Il foro principale deve essere a
25 mm dallo spigolo superiore del rivestimento.
Segnare la posizione delle viti con una matita (1)
e praticare i fori con un punteruolo (2). Forare il
rivestimento con una punta da ø 3 mm (la profon-
dità dei fori deve essere di 15 mm) (3). Mettere la
guarnizione sulla parte esterna dei rivestimenti.
Fissare la tenda con le viti fornite (4).
ESPAÑOL: Instalación a realizar por el exterior:
Coloque el toldillo centrado en la ventana. El
orificio superior debe quedar a 25 mm del borde
del perfil. Marque la posición de los orificios de
los extremos del toldillo (1). Inicie los orificios
golpeando sobre un punzón (2) y taladre utilizando
una broca de Ø 3 mm. Profundidad del taladro =
15 mm (3). Coloque los selladores por el exterior de
los perfiles. Fije el toldillo con los tornillos (4).
ø 3 mm
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velux MAG - GIL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velux MAG - GIL in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info