567744
12
Zoom out
Zoom in
Previous page
1/29
Next page
12
Setup Wi-Q User’s Manual
Step 5: Place/Connect Subwoofer
Subwoofer Placement
True subwoofers operate at extremely low frequencies which are primarily omni-directional.
Depending on the acoustic properties of the listening room, placement can drastically influence your
subwoofer’s frequency response and output levels.
Use the following guidelines to find the optimal location for your subwoofer:
For highest output, place the subwoofer within one foot of a corner; this location offers the
greatest output levels.
For smoother response, but less output, place your subwoofer along a wall.
The worst location for a subwoofer is away from any walls, close to the center of a room, or
close to a doorway or opening to another room. Avoid these locations when possible.
When using a pair of Velodyne subwoofers in stereo, feed each subwoofer with one channel
and place each subwoofer near the satellite of the same channel. You can also place one
mid-way along a wall and the other in a corner for a very smooth, deep response.
Depending on the size and type of furnishings in the room, you may not be able to achieve
perfect placement. We suggest that you experiment with the location during setup to find what
sounds best when seated in your typical listening position.
For more information on placement, see
Velodyne’s Subwoofer Placement Recommendations
Guide (http://velodyne.com/support/faq#sub).
Regardless of where you install your Velodyne subwoofer, it must remain in an upright position
(woofer facing forward). Do not use, ship, or store the subwoofer in any other position for an
extended period of time; this may damage the unit and this type of damage is not covered
by the warranty.
The subwoofer is NOT magnetically shielded. If you use it with an older CRT monitor or TV,
keep it at least two feet from the monitor. Experiment for correct minimum distance by
minimizing distortion of the picture and colors.
Connect Subwoofer
1. Determine optimal placement as described in the previous section.
2. Connect the female end of the power cable to the back of the subwoofer and the male end to a
power outlet.
3. Press the POWER button on the back of the subwoofer, so that it is in the ON position.
Caution
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to
sources of heat such as direct sunlight, furnace registers, radiators, etc. Do not place
the unit near sources of excessive moisture such as high humidity environments,
evaporative coolers, humidifiers, etc. The power cord should be routed in such a way
that it will not be walked on, pinched or compressed in any way that could result in
damage to the insulation or wire.
Warning
To prevent fire or shock hazard, do not expose this product to rain or moisture. To avoid
electrical shock, do not open the speaker enclosure or amp chassis cover. Please
observe all warnings on the equipment itself. There are no user serviceable parts inside.
Refer all service questions to your authorized Velodyne dealer.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velodyne Wi-Q12BV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velodyne Wi-Q12BV in the language / languages: English as an attachment in your email.

The manual is 4,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info