567837
15
Zoom out
Zoom in
Previous page
1/30
Next page
www.velodyne.com
SC-1250 Amplier User’s Manual - 9
(18) Speaker Level Input Terminals (See Figure 5)
Connecttheseinputterminalstothespeakeroutputterminalsofyouramplierorreceiver.Ifyouuse
this method of connection, when you go to the receiver speaker set up menu, make sure you select the
“large” speaker option.
(19) Subwoofer Connection Terminals
Connect these output terminals to the subwoofer(s) being controlled by the SC-1250. Onlyconnect ONE
subwoofer per red/black pair of subwoofer output terminals - DO NOT connectthe subwoofers in a
“daisychain”conguration.
Note: SC series subwoofers are designed so that TWO subwoofers can be driven from asingle SC-1250
amplier.IfyouareusingtheSC-1250topoweranon-SCsubwoofer,makesureyouchecktheresistanceof
the subwoofer’s voice coil. A SINGLE 4 ohm subwoofer canbe driven with the SC-1250, but not TWO 4 ohm
woofers. If you attempt to run more than asingle 4 ohm subwoofer, internal protection circuitry will activate
within the SC-1250.
Caution!!!
To avoid damage to your SC-1250, be sure to maintain correct polarity when making all connections. Red
(positive) to red, and black (negative) to black. Be sure that all connections are tight, and that there are no loose
strands or frayed wires.
(20) Power Cord Adaptor
Connectthedetachable117V~60Hz15AACpowerplugtothismaleinterfaceconnection.Thedetachable
cord allows for easy replacement should the original be damaged.
(21) Fuse
If the unit is not functioning, check the fuse. If the fuse is blown, replace with an identically rated fuse. If
the fuse blows again, refer the unit for service.
(22) Master Power Switch
PressthePOWERswitchtotheONpositiontoactivatetheamplier.Iftheunitistobeleftunusedfor
anextendedperiodoftime,movethisswitchtotheOFFpositiontoprolongthelifeoftheamplier.
REAR PANEL CONNECTIONS – DETAILED EXPLANATION
TheSC-1250isequippedwithbothspeaker-levelandline-levelinputs.UsetheRCA/Phonotype“INPUT”jacks
whenconnectingfromapre-amp,signalprocessor,orline-levelcrossover.The“SPEAKERLEVELINPUT”jacks
connectdirectlytothespeakeroutputsofanintegratedamplierorreceiver.Yourampliersectionwillnotice
noadditionalloadingeectswhenyouusetheseinputsbecauseoftheirhighimpedance.
Note: Do not use both the RCA/Phono “INPUT” connections and “SPEAKER LEVEL INPUT” connections
simultaneously.
About Low-Pass Crossovers
All of the SC-1250 inputs sum the left and right channels together and the resulting signal is passed through
anadjustablelow-passcrossoverbeforebeingamplied.Thecrossovercontrolallowsyoutoadjusttheupper
limitofthesubwoofer’sfrequencyresponsefrom30to160Hz.Thesubwoofer’sresponsewillbeginrollingo
abovethefrequencyyousetthiscontrolto.Theslopeis24dB/octave.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velodyne SC-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velodyne SC-8 in the language / languages: English as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info