567719

Velodyne MiniVee Manual

10
Zoom out
Zoom in
Previous page
1/20
Next page
www.velodyne.com
4 - MiniVee User’s Manual
Auto Turn on Function
With this function in the “auto” position, your subwoofer can be safely left with the main power switched on
continuously. The subwoofer will turn itself on automatically when an audio signal is present. If no signal is
present for approximately 10 minutes, the unit will switch to standby mode. While in standby mode, your
subwoofer will draw very minimal power. This function can be disabled by leaving the switch in the “on” position.
Power Switch
Themasterpowerswitchislocatedonthelowerhalfoftheunit.Thisrockerstyleswitchisthemainon/ofor
theunit.Thisswitchshouldbesettoposition1(up)foron,and0(down)foro.Iftheunitistobeleftunused
foranextendedperiodoftime,themasterpowerswitchshouldbeturnedo.
Subwoofer Outputs
The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the built-
incrossover.Someprocessors/receivershavea“subwooferout”jackthatisinternallylteredanddesignedto
beusedwithaconventionalamplierandspeaker.Insomerarecases,combiningbothanexternalcrossover
and the one internal to the subwoofer may result in low output and increased noise. In these installations you
may need to bypass the internal crossover in either the processor or Velodyne subwoofer. In some installations,
simplysettingonecrossovertoahigher frequency(suchas120Hz)willrestoremaximumperformance.To
bypass the subwoofer’s internal crossover when the unit is being fed a low pass signal from another crossover,
simply locate the switch marked INTERNAL X-OVER/SUBWOOFER DIRECT on the rear panel of the subwoofer
and set to the SUBWOOFER DIRECT position. This will eliminate the internal crossover from the signal path.
Note:Ifnotusinganexternalcrossover,youshouldusethebuilt-incrossoverforoptimalperformance.
LINE-LEVEL CONNECTION - OPTION A
Figure1showsconnectionfromyourhometheaterreceivertotheLFEinputonthebackofyoursubwoofer.
Whenthesubwooferisinstalledinthisfashion,allofthelowfrequencyinformationfromyour“LFEOut”or
“Subwoofer Out” on the back of your receiver will pass into your Velodyne subwoofer. This connection is the
mostcommonconnectionmethodwhenusingyoursubwooferwitha5.1receiver.(Cableneeded:1monoRCA
cable.)
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velodyne MiniVee at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velodyne MiniVee in the language / languages: English as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info