567708
15
Zoom out
Zoom in
Previous page
1/42
Next page
If using the video output display, night mode shows as active below the Preset note on the Introductory screen. Night mode can be modified in
the “Next” page of either the video output menu or the Windows Setup Program.
A
ctive, Inactive & 12V Trigger Power Modes
The subwoofer has three power ON modes. These modes help the user control power conservation when the subwoofer isn’t playing,
b
ut allow the subwoofer’s power switch to remain ON at all times.
In the active mode, the subwoofer’s standby mode is on. When the subwoofer gets an audio signal input, the internal amplifier turns on
to play the audio. It takes a few seconds for the DSP processor to boot-up and then you hear the audio.
If the subwoofer is in active mode and doesn’t receive an audio signal, the subwoofer automatically goes into standby mode to save
power. This takes between 10 to 15 minutes.
In standby mode, the subwoofer’s power switch is ON and its internal amplifier isn’t on.
If the subwoofer will be left in standby for a period of greater than 5 days,
Velodyne recommends turning off the power switch.
• In the inactive mode, the standby mode is defeated.
In the inactive mode and when the subwoofer power switch is ON, its internal amplifier is on even if the subwoofer isn’t receiving
an audio signal.
If the subwoofer will be left inactive for a period of greater than 5 days,
Velodyne recommends setting the power switch to OFF.
• In the 12V trigger mode, the subwoofer turns on with a 12V source (from a controlling receiver) at its 12V trigger jack.
In 12V trigger mode and when the subwoofer’s power switch is ON, its internal amplifier isn’t on until it receives 12V in either polarity
at the 12V trigger jack.
In 12V trigger mode, if the 12V trigger is not applied, the subwoofer will not respond to the remote control. To reset the mode, apply the
trigger and then use the remote or Windows Setup Program to effect the change.
If the subwoofer will be left inactive in 12V trigger mode for a period of greater than 5 days,
Velodyne recommends setting the power switch to OFF.
Light Mode
When the light mode is OFF, the LED display behind the front grille is always off, except when momentarily lit to show a change in the volume
or crossover settings or the status of the Auto-EQ
PLUS
process. When light mode is ON, the LED display always shows the volume, except it
does reflect changes in crossover settings or the status of the Auto-EQ
PLUS
process and then reverts to volume. Having the LED on at all
times can be distracting in a darkened listening room, so the default setting is OFF.
Protection Circuitry
The subwoofer is equipped with protection circuitry to provide maximum performance with greatest reliability. The subwoofer is
protected against:
Overdriving the speaker
Overdriving the amplifier
Overheating the amplifier
Excessive drop in power line voltage
[ 12 ]
D
igital Drive
P
LUS
U
ser’s Manual
FEATURES
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velodyne DD-10plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velodyne DD-10plus in the language / languages: English as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Velodyne DD-10plus

Velodyne DD-10plus Quick start guide - English - 2 pages

Velodyne DD-10plus User Manual - English - 40 pages

Velodyne DD-10plus Quick start guide - German - 2 pages

Velodyne DD-10plus User Manual - German - 20 pages

Velodyne DD-10plus User Manual - German - 36 pages

Velodyne DD-10plus Quick start guide - French - 2 pages

Velodyne DD-10plus User Manual - French - 47 pages

Velodyne DD-10plus User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info