521336
2
Zoom out
Zoom in
Previous page
1/16
Next page
- 3 -- 2 -
VELLEMAN-KIT
3D Printer kit
Order code: K8200
manufactured by:
VELLEMAN NV.
Legen Heirweg, 33
9890 Gavere
Belgium
CE conformity information:
The K8200 is a DIY 3D printer kit, it contains all the bits and pieces to construct your own 3D printer but does not contain
additional protection.
As it is a kit and not a nished product, compliance with the CE regulations depends on the build-quality; also the following
notes must be taken into account.
Conductive EMC towards the public distribution network is not an issue as this is related to the power supply.
Radiated EMC depends substantially on the build quality, it might be required to add shielding but this cannot be predicted.
A built K8200 should comply with EN50081 normation
Electromagnetic radiation (EMC):
The included power supply meets all the applicable European requirements and bears the CE-mark.
It is protected against overload and short circuit and nothing needs to be modied. The working voltage of the 3D printer is
15Vdc (extra low voltage) and therefore it’s outside the scope of the Low voltage directive.
Always unplug before maintenance or modication.
Electrical safety:
!
Important safety instructions
������������������ ��������������������
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velleman K8200 - 3D-printer bouwpakket at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velleman K8200 - 3D-printer bouwpakket in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info