573322
70
Zoom out
Zoom in
Previous page
1/79
Next page
MANUAL
VECTRON COMMANDER
PAGE 70/70
Name
Enter a name for the ECR. Be descriptive.
ECR type
Select the type of ECR from the list. COMMANDER 6 only supports Vectron
hardware.
Address
Enter the network address of the ECR (HARDWARE PARAMETERS/NETWORK
ADDRESS in Vectron POS)
Password
Password to allow the PC access to the terminal. If a password is set in the
terminal, it must also be set here. If it is not set in the terminal, leave this blank.
Do not use the same passwords you have used in Parameters.
Phone number
If this is blank, it is assumed to be a direct connection. If the terminal is
connected via modem, enter the phone number to call.
Channel type
Select the channel the ECR (or modem) is connected on. This will usually be a
Com Port.
Baud rate
Enter the Baud rate that this ECR will communicate at. This must be set the
same as the HARDWARE PARAMETERS/PORT X BAUD RATE setting of the
ECR. Note: For modem connections, set this to 9600, as higher baud rates may
be unreliable due to the quality of the phone lines.
Delay
If the PC cannot connect to the ECR, wait this many seconds before retrying.
Default value is 60 seconds.
Tries
The number of times that COMMANDER will attempt to connect to this ECR.
9.5.3Communication
Init with 8N1
NormallysettoNO.OnsomePCs,thismayhavetobesettoYEStoestablish
communications.
Handshake
NormallysettoNO.OnsomePCs,thismayhavetobesettoYEStoestablish
communications.
Timeout ENQ -> Timeout send data
Time in seconds that COMMANDER waits for a response from the ECR to each
of these commands. Normally these can be left blank.
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vectron Commander 6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vectron Commander 6 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vectron Commander 6

Vectron Commander 6 User Manual - German - 146 pages

Vectron Commander 6 User Manual - Dutch - 131 pages

Vectron Commander 6 User Manual - French - 143 pages

Vectron Commander 6 User Manual - Spanish - 122 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info