98458
12
Zoom out
Zoom in
Previous page
1/18
Next page
15
Note 3: Do not touch the electrical contacts
when removing or replacing the front panel!
GENERAL OPERATION
Switching On/Off
Press button to switch the set on or off.
Setting the Start-up Volume
VOL LAST or VOL ADJ mode
In this mode the start-up volume can be set the
radio will have when it is switched on.
1. Long press the SEL MENU knob to select
the special functions mode.
2. Turn the VOL knob to VOL LAST to set the
radio to store the volume as it was when the
radio was turned off, or
3. Turn the knob to VOL ADJ to adjust the start-
up volume with the VOL knob to a comfort-
able level.
Note: If the radio was previously at a higher
volume level when you turned off the radio: After
you turn on the radio, the radio will use the start-
ing volume. Otherwise the radio will remember
the previous volume level.
Selecting a Source
Your car radio is designed for different types of
sources.
z RADIO
z CD
z AUX
1. Press the SEL MENU knob.
2. Turn the VOL knob to select the source.
Sound Controls
Volume
Please make sure you can still hear the traffic
(horns, sirens..….)
z Turn the volume knob to adjust the volume.
Note: You can adjust the start-up volume VOL
LAST/VOL ADJ. When the start-up volume is set
to maximum level, it may be extremely loud
when you switch on the set.
z Short press the SEL MENU knob.
When VOL is displayed turn the VOL knob to
adjust the volume to your requirements.
See: Setting the Start-up Volume
Balance
To change the balance between the amount of
sound output on the left and right side.
1. Press the SEL MENU knob to select the
sound control Balance (BAL).
2. Turn the VOL knob to adjust the level of
sound output to the left and right speakers.
Bass (only when DSP is off)
To change the enhancement of low frequency.
1. Press the SEL MENU knob to select the
sound control Bass (BAS).
2. Turn the VOL knob to adjust the level of
bass enhancement.
Treble (only when DSP is off)
To change the enhancement of high frequency.
1. Press the SEL MENU knob to select the
sound control Treble (TRE).
2. Turn the VOL knob to adjust the amount of
treble enhancement.
Fader
To change the amount of sound output to the
front and rear speakers.
1. Press the SEL MENU knob to select the
sound control Fader (FAD).
2. Turn the VOL knob to adjust the level of
sound output to the front and rear speakers.
Equalizer
Radio
1. Long press the SEL MENU knob to select
the special functions mode.
2. Turn the VOL knob to DSP ON to select one
of the programmed equalizer settings.
Remote control
Press the EQ button on the remote control to
select one of the programmed equalizer settings.
z Classic (CLAS)
z Rock (ROCK)
z Pop (POP)
z Flat (FLAT)
Mute
Press the Mute button to mute the sound. If a
CD is playing, it will be paused. Press the Mute
button again to restore the sound and the CD
will continue playing.
Loudness
Radio and Remote Control
Long press the Loud button to enhance the high
and low frequency sound quality.
Setting time
In Radio or CD-mode the internal clock of the
radio can set.
1. Long press the DISP button until the clock
display is flashing.
2. Turn the volume knob either to the left or
right to set the HOUR.
3. Press the SEL MENU knob to enter the cur-
rent setting.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VDO Dayton CD1107 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VDO Dayton CD1107 in the language / languages: English as an attachment in your email.

The manual is 3,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of VDO Dayton CD1107

VDO Dayton CD1107 User Manual - German - 19 pages

VDO Dayton CD1107 User Manual - Dutch - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info