540867

VAX V-125 Manual

10
Zoom out
Zoom in
Previous page
1/20
Next page
www.vax.co.uk
10
how to clean
Continue using dry strokes until little water is visible
passing through the recovery tank lid.
For best results, use straight, parallel strokes. Overlap
strokes by 3cm to help prevent streaking. Keep nozzle flat
on floor for both forward and reverse strokes (Fig. 5/3).
If rinsing the carpet is desired, set Wash/Rinse switch to
RINSE (Fig. 5/4).
Rinsing is not necessary, but will help remove solution
residue and help your carpet look fresher.
For heavily soiled areas, repeat steps 5/2-5/4. Avoid
saturating carpet, as noted below.
NOTE:
To avoid saturating carpet, do not use more
than 4 wet strokes over one area. Always end with dry
strokes.
It is best to alternate wet and dry strokes as described above
.
For best cleaning results and to aid in faster drying of
carpet, end with more dry strokes. (Continue using dry
strokes until little water is visible passing through the
recovery tank lid.)
Empty recovery tank when the motor sound becomes
higher pitched and there is a loss in suction (see
“Automatic shut-off”, Fig. 4/5).
When finished cleaning, follow “After cleaning”
instructions on page 10.
Cleaning Hard Floors
Attaching Hard Floor Tool
IMPORTANT: Unplug cleaner from electrical outlet.
To prevent possible leaking, remove clean water tank (Fig.
4/9) and recovery tank (Fig. 4/16). Set tanks aside (do not
sit tank on furniture). With handle in upright position, tilt
cleaner back so that handle rests on the floor.
Remove brush assembly with green bristles. Attach hard
floor brush assembly with the white bristles. Lift up rear
edge of nozzle. Slide nozzle up and remove from cleaner
(Fig. 5/5).
Position the bottom of the nozzle (A) inside the squeegee
(B), with the tabs (C) on the squeegee behind the nozzle as
shown (Fig. 5/6).
Rotate the squeegee back until secure, making sure the
outside edges are pushed up tight against the nozzle.
To replace nozzle, line up tabs on nozzle with holes (E) in
cleaner. Slide tabs into holes.
Slide no
zzle completely onto cleaner. Press down on
nozzle to secure it. Replace recovery tank.
NOTE: The nozzle must be in the proper position in
order for the recovery tank to go on properly.
Raise handle t
o uprigh
t position and r
eposition clean
wa
t
er tank.
➡
➡
➡
➡
➡
➡
Fig.5/3
O
N
O
F
F
W
A
S
H
A
U
T
O
R
IN
S
E
R
i
n
s
e
Fig.5/4
Fig.5/5
Fig.5/6
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VAX V-125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VAX V-125 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info