Using your machine Using your machine
To produce steam squeeze
the trigger. To prevent overly
wetting the carpet, avoid
holding the trigger
continuously
Move the steam mop slowly
backwards and forwards
across the carpet paying
particular attention to high
trac areas
To release the carpet
glider, place foot on clip
and push down. Lift
steam mop to unhook
and remove
Refreshing carpets
To recline the steam mop
place foot on oor head and
pull handle backwards
Place foot on outer
oor head and gently pull
away steam mop to release
the compact scrub brush
Move steam mop back and
forwards across the oor,
getting into corners and
awkward places
Using accessories
• Thesteammopandaccessoriesgetveryhotduringuse,alwaysallowthemtocooldownbeforehandling.
• Alwaysunplugandswitchothesteammopwhenassembling.
• Alwaysswitchothesteammopbeforeemptyingthewatertankorchangingthecleaningpads/accessories.
• IMPORTANT: Please refer to oor manufacturer’s care recommendations before use and test the steam mop
on a discrete area of ooring to begin with.
• Whenusingthesteammop,basicsafetyprecautionsshouldalwaysbeobserved.
• Don’taimthesteammopatpeople,animals,plantsandelectricalcomponentssuchasinteriorofovensorwires.Nevertouch
the steam burst or oor head from a short distance. (There is a risk of scalding)
• Thesteammopisequippedwithathermostatandathermalcut-out.Ifforanyreasonthesteammopoverheatsit
will switch o. If this happens turn o and unplug the steam mop, allow to cool for a least 2 to 4 hours and re-start.
IMPORTANT:
When using on carpets, always make sure the velcro microbre cleaning pad is used and covers the oor head
entirely before using the carpet glider. Only use the carpet glider when refreshing carpets and turn the detergent dial to OFF.
Place the microbre
pad on the oor white
side facing up. Place
steam mop onto pad
making sure the entire
pad covers the
oor head
To steam your oors
with detergent turn the
dial to ON and without
detergent turn the
dial to OFF
Plug into mains and
press the power button
to switch on. The blue
light will illuminate to
show power on. The
green light will illuminate
to show the steam
mop is ready to use
Adjust the steam dial to
desired setting
To recline the steam
mop place foot on oor
head and pull handle
backwards
Using the steam mop
Move the steam mop
slowly backwards and
forwards across the oor
paying particular attention
to high trac areas.
Squeeze/release trigger
as required
Push On/O switch to
turn machine on
To produce steam
squeeze the trigger in
short bursts. Don’t hold
the trigger continuously to
prevent over wetting oors
Hold corner of pad down
with foot and lift steam mop
to peel away
Turn the detergent dial to OFF
when refreshing carpets
Place the microbre pad on
the oor white side facing
up. Place steam mop onto
pad making sure the entire
pad covers the oor head
With microbre pad attached,
hook the steam mop into the
front of the carpet glider and
push to clip into place. Carpet
glider should only be used
when refreshing carpets
Push On/O button
to switch on
IMPORTANT: Always switch o the steam mop before attaching or removing the oor head.