1 Set up your VAX as described on page 5
2 Don’t use the extension tubes, but do use the
extension tube adaptor
3 Fit one end of the short transparent tube into the
connector on the hose grip, and the other end into
the upholstery washing tool
4 Turn the suction power to the wash setting
5 Switch ON
6 Switch on the power washing button
7 Start the washing solution flowing
Squeeze the large button in.
8 When you see water swirling in the washing tool
you are ready to start washing
9 Pull the washing tool backwards, continuing to
squeeze the button
You are now washing the upholstery. Cover a small area at a
time. Don’t push the tool backwards and forwards as this may
stretch the fabric.
10 Stop the washing solution flowing
Release the large button.
Go back over the area you have just washed.
You are now removing excess moisture from the upholstery.
11 Move to the next area and repeat as from 6 above
12 When no more water reaches the wash tool you will
see air bubbles in the transparent tube
Refill the clean water bucket with water and VAX carpet cleaner
Empty the dirty water bucket when you refill the clean water bucket.
The ‘sound’ your VAX makes will change and the suction will drop
if the dirty water bucket is over-full. Time to empty it!
7
Tip
Use the upholstery tool for spot cleaning small dirty patches on either
carpet or upholstery.
