581892
12
Zoom out
Zoom in
Previous page
1/15
Next page
POWXQG7571 EN
Copyright © 2014 VARO P a g e | 12 www.varo.com
12.3 Cleaning the mower housing
Dirt deposits make the start difficult, affect the quality of the cut and the discharge of the grass.
Dirt and grass residues are easiest to remove immediately after the mowing. To avoid fouling
the floor, the underside must be cleaned on the grass.
Remove the mulching plug / grass catcher.
Fit the hose connector to the lawn mower and turn on the water tap.
Start the lawn mower and switch it off again after about 30 seconds. The rotating blade
bar will throw the water onto the underside of the lawn mower and thus clean it.
Turn off the water tap and remove the hose connector.
Clean the top with a cloth (do not use any sharp objects).
13 TROUBLESHOOTING
Problem
Probable cause
Corrective action
Engine does not
start
Fuel tank is empty.
Fill tank with fuel
Air cleaner element is
dirty.
Clean air cleaner element
Spark plug loose.
Tighten spark plug to 25-30 Nm.
Spark plug wire loose or
disconnected from plug.
Install spark plug wire on spark plug.
Spark plug gap is
incorrect.
Set gap between electrodes at 0.7 to
0.8mm
Spark plug is defective
Install new, correctly gapped plug
Carburettor is flooded with
fuel
Remove air cleaner element and pull
starter rope continuously until carburettor
clears itself and install air cleaner
element.
Faulty ignition module
Contact the service agent.
Engine difficult
to start or loses
power.
Dirt, water, or stale fuel
tank.
Drain fuel and clean tank. Fill tank with
clean, fresh fuel
Vent hole in fuel tank cap
is plugged.
Clean or replace fuel tank cap.
Air cleaner element is
dirty.
Clean air cleaner element.
Engine
operates
erratically.
Spark plug is defective.
Install new, correctly gapped plug
Spark plug gap is
incorrect.
Set gap between electrodes at 0.7 to
0.8mm
Air cleaner element is
dirty.
Clean air cleaner element
Engine idles
poorly.
Air cleaner element is
dirty.
Clean air cleaner element
Air slots in engine shroud
are blocked.
Remove debris from shots.
Cooling fins and air
passages under engine
blower housing are
blocked.
Remove debris from cooling fins and air
passages.
Engine idles
poorly.
Gap between electrodes of
spark plug is too close.
Set gap between electrodes at 0.7 to
0.8mm
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varo POWXQG7571 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varo POWXQG7571 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varo POWXQG7571

Varo POWXQG7571 User Manual - German - 17 pages

Varo POWXQG7571 User Manual - Dutch - 16 pages

Varo POWXQG7571 User Manual - French - 17 pages

Varo POWXQG7571 Additional guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info