581891
15
Zoom out
Zoom in
Previous page
1/18
Next page
POWXQG7570 EN
Copyright © 2013 VARO P a g e | 15 www.varo.com
If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
10 TRANSPORT
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower
over obstacles.
11 TROUBLES SHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Engine does
not start.
Throttle chock not in the correct
position for the prevailing conditions.
Move throttle chock to correct
position
Fuel tank is empty.
Fill tank with fuel
Air cleaner element is dirty.
Clean air cleaner element
Spark plug loose.
Tighten spark plug to 25-30 Nm.
Spark plug wire loose or
disconnected from plug.
Install spark plug wire on spark plug.
Spark plug gap is incorrect.
Set gap between electrodes at 0.7 to
0.8mm
Spark plug is defective
Install new, correctly gapped plug
Carburetor is flooded with fuel
Remove air cleaner element and pull
starter rope continuously until
carburetor clears itself and install air
cleaner element.
Faulty ignition module
Contact the service agent.
Engine
difficult to
start or loses
power.
Dirt, water, or stale fuel tank.
Drain fuel and clean tank. Fill tank
with clean, fresh fuel
Vent hole in fuel tank cap is plugged.
Clean or replace fuel tank cap.
Air cleaner element is dirty.
Clean air cleaner element.
Engine
operates
erratically.
Spark plug is defective.
Install new, correctly gapped plug
Spark plug gap is incorrect.
Set gap between electrodes at 0.7 to
0.8mm
Air cleaner element is dirty.
Clean air cleaner element
Engine idles
poorly.
Air cleaner element is dirty.
Clean air cleaner element
Air slots in engine shroud are
blocked.
Remove debris from shots.
Cooling fins and air passages under
engine blower housing are blocked.
Remove debris from cooling fins and
air passages.
Engine skips
at high
speed.
Gap between electrodes of spark plug
is too close.
Set gap between electrodes at 0.7 to
0.8mm
Engine
overheats
Cooling air flow is restricted.
Remover any debris from slots in
shroud, blower housing, air
passages
Incorrect spark plug.
Install RJ19LM spark plug and
cooling fins on engine
Mower
vibrates
Cutting assembly is loose.
Tighten blade
Cutting assembly is unbalanced
Balance blade.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varo POWXQG7570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varo POWXQG7570 in the language / languages: English as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varo POWXQG7570

Varo POWXQG7570 User Manual - German - 20 pages

Varo POWXQG7570 User Manual - Dutch - 19 pages

Varo POWXQG7570 User Manual - French - 19 pages

Varo POWXQG7570 Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info