The mower does not turn on or is in low voltage protection state
(the voltage is lower than 16V, the mower should be restarted)
8.1.3 Clear the fault code
To clear the fault code follow these steps:
1. Make sure that all conditions for restarting the mower are met (for the mower itself
and in the mowing area).
2. The status light flashes, this is the error code.
3. The lights 2D-2H-4H and 6H flash, enter the pin code, wait 5 sec.
4. Press CYCLE then HOME to exit the emergency stop mode (The status light and
the mowing setting lights 1D or 2D and 2H or 4H or 6H are steady)
5. Press START followed by CYCLE to start the mower (all lights are off), the mower
will start with a new mowing program after 10 sec.
OR
Press HOME followed by CYCLE to return the mower to the charging station (all
lights are off), the mower will start after 10 sec.
