581887
12
Zoom out
Zoom in
Previous page
1/16
Next page
POWXG60225 EN
Copyright © 2015 VARO P a g e | 12 www.varo.com
Replace worn or damaged parts for safety. For reasons of safety, do not use the
equipment with worn or damaged parts. Parts are to be replaced and not repaired. Parts
that are not of the same quality can damage the equipment and be dangerous for your
safety.
If the fuel tank has to be drained, this should be done outdoors and when the engine is
cool.
Wear strong work gloves when removing and reassembling the blade.
Check the blade's balance after sharpening.
Check the self-closing guard and grass-catcher frequently for wear and deterioration.
Whenever the machine is to be handled, transported or tilted you must:
wear strong working gloves;
grasp the machine at the points that offer a safe grip, taking account of the weight and its
distribution.
11.1 Changing / draining the oil. (Fig. 14)
The oil drain plug is located under the dipstick, at the base of the engine.
Have a container ready to catch the oil and remove the drain plug.
Once the oil has been emptied, replace the drain plug.
Make sure that the washer is in place and wipe any spillages.
Start the engine and allow it to run briefly. Stop the engine, wait one minute and check the oil
level. Top up if necessary.
11.2 Draining the fuel tank / carburetor (Fig. 15)
Place an approved gasoline container below the carburettor, and use a funnel to avoid
spilling fuel.
Remove the drain bolt, then move the fuel valve lever to the ON position.
After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten
the drain bolt securely.
11.3 Spark plug (Fig. 16)
Allow the engine to cool down.
Remove the spark plug using the box spanner supplied, clean the plug with a wire brush. Set
the gap to 0.75 mm ( 0.030") using a feeler gauge.
Refit the spark plug taking care not to overtighten it.
Use only correct type spark plug. For best results, replace the spark plug every 100 hours of
use.
11.4 To clean air filter (Fig. 17)
Unclip the air filter cover and remove the sponge filter element. (To avoid objects falling
into the air intake, replace the air filter cover).
11.5 Cleaning the mower housing
Dirt deposits make the start difficult, affect the quality of the cut and the discharge of the grass.
Dirt and grass residues are easiest to remove immediately after the mowing. To avoid fouling
the floor, the underside must be cleaned on the grass.
Remove the mulching plug / grass catcher.
Fit the hose connector to the lawn mower and turn on the water tap.
Start the lawn mower and switch it off again after about 30 seconds. The rotating blade
bar will throw the water onto the underside of the lawn mower and thus clean it.
Turn off the water tap and remove the hose connector.
Clean the top with a cloth (do not use any sharp objects).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varo POWXG60225 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varo POWXG60225 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varo POWXG60225

Varo POWXG60225 User Manual - German - 19 pages

Varo POWXG60225 User Manual - Dutch - 17 pages

Varo POWXG60225 User Manual - French - 18 pages

Varo POWXG60225 Additional guide - All languages - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info