756787
5
Zoom out
Zoom in
Previous page
1/7
Next page
POWX4201 EN
Copyright © 2021 VARO P a g e | 5 www.varo.com
final charging step, maintenance charging, maintains the battery capacity at 95100% and
therefore keeps the battery fully charged at all times. The charging operation does not need to
be monitored. However, do not leave the battery unattended if you charge it over an extended
period of time, so that you can disconnect it from the mains power supply in the event of a
fault in the charger.
7.2 Explanation of the symbols (fig.1)
A Battery charging status: 25%
B Battery charging status: 50%
C Battery charging status: 75%
D Battery charging status: 100%
E Charging of a 12V battery (lead acid battery,AGM battery and GEL battery).
F Charging of a 12V battery (lead acid battery,AGM battery and GEL battery) in winter
mode with an ambient temperature of 20°C to 5°C.
G Charging of a 12V battery (lead acid battery,AGM battery and GEL battery) in charge
maintenance mode with 1A charging current.
H Clamps are wrongly connected (reverse polarity) or there is a short-circuit.
7.3 Charging settings
Press the Mode button (1) to set the charging functions 12V (E) and 12V Winter Mode (F).
For batteries with low capacity or for maintenance-charging of seasonal batteries you can
use the “Maintain” mode with reduced maximum charge current. One of the LEDs will
come on in accordance with the settings you have selected (E-G).
7.4 Charging the battery
Release or remove the battery stoppers (if fitted) from the battery.
Check the acid level in the battery. If necessary, top up the battery with distilled water (if
possible). Battery acid is aggressive. Rinse off any acid splashes thoroughly with lots of
water and seek medical advice if necessary.
First connect the red charging cable to the positive pole of the battery.
Then connect the black charging cable to the bodywork of the vehicle away from the
battery and the petrol pipe.
Warning! Under normal circumstances the negative battery pole is connected to the
bodywork and you proceed as described above. In exceptional cases it is be possible that
the positive battery pole is connected to the bodywork (positive earthing). In this
case,connect the black charger cable to the negative pole on the battery. Then connect
the red charger cable to the bodywork at a point away from the battery and the petrol pipe.
After the battery has been connected to the charger, you can connect the charger to a
socket. All the LEDs will flash for a short time. Then the LED (E) will shine continuously as
soon as the charging status of the battery is indicated. You can now change the charging
settings. LEDs (A-D) will blink in succession until the battery is fully charged (provided it is
not defective). When the battery is fully charged, the LEDs A-D will be lit continuously.
If only the LED flashes (E), this means that although the charger is connected to the
socket, it is not connected to the battery.
Important! Charging may create dangerous explosive gas and therefore you should avoid
spark formation and naked flames whilst the battery is charging. There is a risk of
explosion! It is essential that you ventilate the rooms well.
If the charger shows “Battery fully charged” after just a few minutes, this indicates that the
battery capacity is low. The battery needs replacing.
7.5 Calculate the charging time (fig.2)
The charging time depends on the charge status of the battery. If the battery is fully
discharged, the approximate charging time up to approx. 80% charged can be calculated
using the following formula:
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varo POWX4201 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varo POWX4201 in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varo POWX4201

Varo POWX4201 User Manual - German - 8 pages

Varo POWX4201 User Manual - Dutch - 8 pages

Varo POWX4201 User Manual - French - 8 pages

Varo POWX4201 Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info