POWEG63705 EN
Copyright © 2021 VARO P a g e | 9 www.varo.com
8.3 To adjust the rear wheel cutting height position (Fig. 3b & 3c)
▪ Turn the mower on its side.
▪ Pull the rear wheel axle towards the mower’s catcher flap.
▪ Locate the wheel axle into the desire cutting height adjustment position.
Note: Make sure that both rear right and left wheel are located in the same
cutting height adjustment position.
8.4 Power connection
The mains voltage (220-240 V) indicated on the rating plate must correspond with the mains
power supply. Mains connection fuse: min. 10A.
▪ Insert the plug of the mower into the socket of the extension cable.
▪ To prevent the extension cord from disconnecting during use, fit the extension cord
(socket end of cord) through the loop of the cable strain relief and secure over the hook
before connecting the plug.
8.5 Switching on and off (Fig. 4)
WARNING！Do not switch on the unit until it has been completely assembled.
Before switching on the unit, always check the connection cable for signs of
damage, only undamaged connection cable may be used.
Note: Damaged connection cables are highly dangerous!
If you try to start the lawn mower in long grass, the motor might overheat and
become damaged.
▪ Switch on: firstly press the safety button (5) on the combined switch and keep it down,
then pull the switch lever (6) and hold it pressed.
▪ Switch off: release the switch lever (6).
Note: While mowing, lay the connection cable safely on footpaths and on
areas which have already been mown.
WARNING！When the motor has been switched off, the cutter continues
running for several seconds therefore do not touch the underside of the
mower until the cutter has come to a standstill!
8.6 Mowing your lawn (Fig. 5)
Select the cutting height which will suit your desired grass height. If necessary, mow in several
layers so that a maximum grass height of 4 cm will be cut in one single pass.
Make sure that you will avoid paths which could hamper free movement of the extension
cable.
Empty the grass box (2) once it is full to avoid obstruction of the discharge opening. To avoid
obstruction of the discharge opening and unnecessary motor overloading, make sure that you
will not move over any grass left on that part of the lawn you have already mowed.
We recommend to use your mower as outlined below in order to achieve optimum results and
to reduce the risk of cutting the mains cable.
▪ Place the bulk of the mains cable close to the starting point.
▪ Switch the mower on as described above.
▪ Proceed as shown in fig.4
