813320

Varde Samso Multi-fuel Manual

11
Zoom out
Zoom in
Previous page
1/24
Next page
11
How to Light and Maintain a re:
The rst time the stove is lit the outer casing will temper. To allow the appliance to settle, and fixing
glues and paint to fully cure, operate the appliance at a low temperature for first few days.
During this time the appliance may give off some unpleasant odours. Keep the room well ventilated to
avoid a build-up of fumes. The tempering will soften the outer casing making it susceptible to damage,
exercise caution and avoid touching. Varde Ovne also recommend opening and closing the door at
regular intervals for the first few hours of use to prevent the rope seal from sticking to the finish.
DO NOT use highly inammable uids such as methylated spirits or petrol for lighting the stove.
Varde Ovne recommend a "Top-down" lighting method, where you light the wood in the upper area
of the combustion chamber rather than the base. This method is the most efcient way to light a re,
and will keep the glass clean. In the bottom of the combustion chamber make a cross with 4 small
pieces of wood, with a small distance between each log. On top of them make another cross, using
8-12 smaller pieces of wood, followed by 2-3 kindling blocks on top of them.
Wood burns best on a bed of ash (approx. 25mm (1") deep).
If burning solid fuel place a small amount around the stack in order to heat these during the initial
lighting.
Before lighting open the Primary Air and the Airwash Controls to allow primary air to circulate through
the rebox.
When the re is established close the Primary Air Control to avoid overring, which could invalidate
the warranty.
Add more solid fuel at this stage.
Use the Airwash Control to adjust the heat. Do not close the Airwash Control or the re will die out.
When running the appliance refuel little and often for clean, efcient burning when burning wood.
A bright and clean rebox indicates the appliance is burning well.
Note: The height and draught of the chimney, as well as the quality of the wood being burnt, are
deciding factors in determining optimal combustion.
Experience establishes settings to suit personal preferences.
If the re is running too hot it is possible to reduce the heat output of the stove:
Burn a smaller amount of wood than usual, eg. 1.2-1.3kg, and if possible use 3-4 small pieces of
wood. Apply Primary Air to ignite the wood and then adjust the Airwash Control to around 60%. Do
not close the Airwash Control or the re will die out. Using this method it is possible to reduce the
nominal output of the stove from 5kW to around 3 - 3.5kW.
Important: This method can lead to poor combustion as restricting the Airwash Control too much can
lead to a lower efciency and an increase in smoke and emissions.
Do not use aerosol sprays near an operating appliance.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varde Samso Multi-fuel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varde Samso Multi-fuel in the language / languages: English as an attachment in your email.

The manual is 1.49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varde Samso Multi-fuel

Varde Samso Multi-fuel Additional guide - English - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info