382344

Vaporetto 3000 eco pro Manual

8
Zoom out
Zoom in
Previous page
1/12
Next page
VAPORETTO ECO PRO 3000
47
E
E
N
N
G
G
L
L
I
I
S
S
H
H
from the mains.
5c.Unscrew anti-clockwise the patented sa-
fety cap (A)
6c.Wait for a few minutes to allow the gene-
rator tank to cool down.
7c.When cool, proceed to carefully refill the
tank as described in paragraph 1 of the
section “Preparation for Use”. If refilling
the generator when not completely coo-
led, we recommend that you carefully
pour only very small quantities of water at
each pouring into the tank, so as to avoid
spitting from the tank and cover exposed
skin and face whilst filling.
U
U
S
S
E
E
O
O
F
F
T
T
H
H
E
E
P
P
R
R
O
O
F
F
E
E
S
S
S
S
I
I
O
O
N
N
A
A
L
L
I
I
R
R
O
O
N
N
(
(
o
o
p
p
t
t
i
i
o
o
n
n
a
a
l
l
a
a
c
c
c
c
e
e
s
s
s
s
o
o
r
r
y
y
)
)
1d.Connect the connector assembly at the
end of the iron hose (4) to the generator
as shown in point 2a of the section “In-
structions for Use”.
Check the manufacturer’s label on the gar-
ment, and interpret the symbol on the label as
follows:
STEAM IRONING
2d.For STEAM ironing, turn the dial (S) and
set the iron temperature to its maximum
travel on the “COTTON-LINEN” steam po-
sition.
NB YOU MUST SET AT ITS MAXIMUM
POSITION, DO NOT SET AGAINST
PICTURE OF THE IRON ON THE DIAL
(S).
Most types of fabric, other than delicates
can be STEAM ironed at this temperature,
please consult the garment manufac-
turer’s instructions on the label.
NB fabric indications on dial are for
DRY ironing, NOT steam ironing.
3d.Wait for a few minutes until the “Iron hea-
ting” indicator light (V) goes off, to show
that the soleplate of the iron has reached
the required temperature.
4d.Press the steam request button (R) to en-
able the steam to come out. The steam
flow will stop when the button is released.
After each filling, when you first start to
use the iron, a few drops of water mixed
with the steam may be emitted (due to im-
perfect heat stabilisation). It is therefore
advisable to direct the first jet of steam
onto a rag.
5d.The iron can also be used in a vertical po-
sition e.g. for removing creases from cur-
tain, clothing etc.
6d.To obtain a continuous jet of steam move
the sliding button (U). The steam will con-
tinue to come out even when the steam
request button (R) is released. To stop the
flow of steam push the sliding button (U)
backwards.
NOTE: using the iron, it is advisable to ad-
just the steam jet at medium output, or to
do some testing in order to find the jet
which is most suitable to the fabric to be
ironed.
RECOMMENDED TECHNIQUE for
steam ironing with the Polti iron is to AP-
PLY steam (button R) on the upstroke,
then release button R (so no steam) for
the backstroke, thus reclosing the fibres,
preventing oversteaming and wetness.
DRY IRONING
• If you need to DRY iron (ONLY) (NOT
steam ironing), press the accessory on/off
switch (C) and adjust the temperature of
the iron by setting the dial (S) to the tem-
perature required for the fabric (as shown
on the dial).
ATTENTION: when dry ironing, be careful
not to press the steam request button (R),
as hot water could come out of the iron onto
your garment and board.
Steam ironing allowed--set the dial to its
MAXIMUM travel at the end of the 3
dots symbol on your Polti iron
Steam ironing allowed--set the dial to its
MAXIMUM travel at the end of the TH-
REE (nb THREE, not two) dots symbol
on your Polti iron
DRY IRON only, with iron dial set at one
dot. N.B. NEVER CALL FOR STEAM
BY PRESSING STEAM REQUEST
BUTTON when DRY ironing. See spe-
cial instructions for DRY ironing in the
instruction book.
DO NOT IRON. Neither steam nor dry
ironing allowed.
VT ECO PRO 3000 M0S07067 - 1O04:VT 2300 M0S05357 1L05 06/05/2008 10.31 Pagina 47
… 8 …


Need help? Post your question in this forum.

Forumrules
1

Forum

vaporetto-3000-eco-pro

Reset search

  • The machine heats up pressure but won't give any steam at all Submitted on 28-8-2022 at 15:18

    Reply Report abuse

  • My 3000 has been unused in its bag in the garage for about 10 years still looks like new. Now when I press the buttons, no lights come on will not work. Fuse tested it ok. Any thoughts why it won’t work. Submitted on 2-9-2020 at 11:57

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaporetto 3000 eco pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaporetto 3000 eco pro in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info