540878
41
Zoom out
Zoom in
Previous page
1/281
Next page
40
2
Fig. 20
3. Attach BLACK test lead clip to engine
ground.
AC output should be no less than 40VAC @3600
RPM.
If no or low output is found:
• Replace stator.
9 Amp DC Output Test
When testing regulator–rectifier for amperage
output, a 12 volt battery with a minimum charge
of 5 volts is required. There will be no charging
output if battery voltage is below 5 volts.
CAUTION: Connect test leads before starting
engine. Be sure connections are secure. If a test
lead vibrates loose while engine is running,
regulator-rectifier may be damaged.
1. Set meter. See Figure 11.
2. Attach RED test lead clip to DC output
terminal ([A] Fig. 21) on regulator–
rectifier.
Fig. 21
3. Attach BLACK test lead clip to positive (+)
battery terminal.
4. Start Engine.
Output should be 3 – 9 Amps @ 3600 RPM.
10 AMP Regulated Alternator
Model 185400
To test alternator output, engine’s electrical
system must be connected to a fully charged 12
volt battery.
1. Adjust governor to 3600 RPM for test.
2. Disconnect battery ground cable from
battery negative (-) terminal.
3. Set meter. See Figure 11.
4. Place DC Shunt #19468 on negative
battery post.
5. Install battery ground cable to DC shunt
battery terminal. See Fig. 22
6. Connect multimeter test leads to DC shunt
terminals, RED to RED and BLACK to
BLACK.
7. Start engine.
Output should be approximately 3 amps @ 3600
RPM.
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard Single Cylinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard Single Cylinder in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info