540878
23
Zoom out
Zoom in
Previous page
1/281
Next page
22
1
Governed Idle RPM Adjustments
(161400, 260700, 261700)
Fig. 31
Install all linkages and springs and be sure that
all carburetor adjustments have been made
before performing any of the running governor
adjustments. To find the correct top no load RPM
by model-type number, log into
thepowerportal.com//repower.
NOTE: (104700) Does not have a governed
idle adjustment.
Early production versions of 260700 and 261700
had governor levers with three spring anchoring
slots. Position spring in middle slot.
Fig. 32
Refer to figure that shows your model.
1. Start and run engine at 1/2 throttle for 5
minutes to bring engine to operating
temperature.
2. Move throttle to SLOW.
3. Align holes in the governor control lever
gear (A) and governor control plate ([B]
Fig. 33 through Fig. 35) Insert 0.125 in.
(3.2 mm) diameter rod (C).
4. Using tang bender tool (D), bend
governed idle speed tang to obtain 1400
RPM.
5. Remove rod ([C] Fig. 33 through Fig. 35).
Fig. 33
Fig. 34
Governed Idle RPM, Fixed Speed Adjustable
(161400 - No Generators)
1. Start and run engine at 1/2 throttle for 5
minutes to bring engine to operating
temperature.
2. Turn speed regulator nut (A)
counterclockwise (CCW) to align idle
speed holes (B) in governor control lever
gear with governor control plate.
3. Insert 0.125 in. (3.2 mm) diameter rod ([C]
Fig. 35).
#19480 or #19229
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard Single Cylinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard Single Cylinder in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info