540881
33
Zoom out
Zoom in
Previous page
1/159
Next page
30
3
3
12. Remove flywheel holder (A) and install
trigger assembly and wire (B).
Figure 22
13. Install oil pick-up tube and strainer with new
gasket.
14. Apply a small bead of Permatex® No. 2 or
other similar sealant (A, Figure 23).
Figure 23
15. Install oil pan with new gasket. Torque
screws and nuts to values shown in Section
14 - Engine Specifications.
16. Install V-belt and fan (if equipped).
17. Install governor lever (A, Figure 24) on to
governor shaft. Do not tighten governor nut
at this time.
18. Install governor link with spring (B).
Figure 24
19. Insert governor spring into original hole in
governor lever.
NOTICE: Governor spring must be installed in
correct hole in governor control lever by engine
model (Figure 25).
• Model 430400 - Top Hole (A)
• Model 580400 - Bottom Hole (B)
Figure 25
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard 3-Cylinder OHV Liquid-Cooled Gasoline at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard 3-Cylinder OHV Liquid-Cooled Gasoline in the language / languages: English as an attachment in your email.

The manual is 10,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info