460104

Valera ManiSwiss 651.01 Manual

4
Zoom out
Zoom in
Previous page
1/57
Next page
Model 651.02: Move the switch (4, fig.1) to switch the
appliance on and off. You can choose between two
rotation speeds: 4500 and 6000 rpm.
CHARGING THE BATTERY
(model 651.02 only)
•Charge the battery for 12 hours before using the
appliance for the first time and whenever the battery
runs flat from use.
•Switch the appliance off at the switch (4, fig.1). The
battery only recharges when the appliance of switched
off.
•Connect the transformer (21, fig.1) to the appliance by
inserting its plug into the socket on the appliance (5,
fig.1).
•Plug the transformer into the mains socket.
•Recharge the battery whenever you notice a drop in
power from the appliance.
•When the battery is fully charged, the appliance can
be used for 60 minutes disconnected from the mains
electricity supply
•The appliance can function both on mains power and
in cordless mode using the rechargeable battery.
•If the appliance fails to function on mains power when
the battery is completely discharged, switch it off,
charge the battery for about five minutes, then switch
it back on again using mains power.
FITTING AND REMOVING
ACCESSORIES
•Only fit or remove accessories with the appliance
switched off.
•Pull the accessory to remove it from the appliance.
To fit an accessory, push it all the way into its seat
(fig.3).
•Model 651.01: Push the sanding rings over their
holder. If necessary, use a suitable tool to remove
them (fig.4).
USEFUL HINTS
- Always use clean and properly disinfected
accessories.
- Make sure that your skin is clean and dry. Avoid
washing hands or feet immediately before beginning
the treatment.
SHORTENING NAILS
Use the fine sapphire cone (7, fig.1). Regular care
helps keep your nails strong.
By abandoning scissors and nail cutters you will be able
to shorten your nails to a more precise length and avoid
ingrown nails.
INGROWING NAILS
Use the needle tip grinder (14, fig.1) or flame tip
grinder (16, fig.1) to treat and prevent ingrown nails.
Proceed in small steps, and with great care. Maintain a
steady hand.
CORNS AND CALLUSES
Use the fine sapphire cone (7, fig.1) to remove hard
skin from corns and calluses.
Finish the treatment with the ball tip sapphire grinder
(15, fig.1).
HARD SKIN AND CALLOSITIES
Pass the coarse sapphire cone (8, fig.1) over the area
to be treated. Repeat until the hard skin or callosity has
been eliminated. On larger areas use the long sapphire
cone (9, fig.1).
SKIN AROUND THE NAILS
To remove dead skin from around the nails, especially
the nails of the feet, use the flame tip grinder
(16, fig.1).
SURFACE OF NAILS
Use the cylindrical grinder (17, fig.1) to grind down
thick nails on the feet. To smooth the surface of nails
and eliminate ridges, use the felt cone (12, fig.1).
CUTICLE SKIN
Treat cuticle skin only when damp.
To push back cuticle skin, use the cuticle tool
(20, fig.1) (model 651.01 only). The tip does not rotate
but performs a forward-backward motion.
POLISHING NAILS
To polish both natural and artificial nails, use the brush
(13, fig.1) (model 651.01 only).
TREATING ARTIFICIAL NAILS
To shorten and shape artificial nails, use the sanding
rings on the relevant holder (18, fig.1) (model 651.01
only).
USING ACCESSORIES FROM
OTHER APPLIANCES
To use accessories from other appliances, use the
spindle (19, fig.1) (model 651.01 only).
PROTECTION AGAINST NAIL DUST
To protect yourself against nail dust during treatments,
use the clear guard (6, fig.1) (model 651.01 only).
CLEANING AND MAINTENANCE
Clean the appliance after every use.
•Switch the appliance off and disconnect it from the
mains supply before performing any maintenance or
changing any parts
•After every use, remove the accessory and clear
guard (if used) (6, fig.1).
•Clean used accessories in denatured alcohol using a
brush or sterilise them in boiling water or in a suitable
steriliser.
5
er
y
ged
if you
or
ns
ection
excess
ce.
eed
holder
only)
nce by
e
cket.
fig.1)
the
500 and
duce
.
pliance
00060557 norme uso INT:Layout 1 17/06/2008 8.28 Pagina 5
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Valera ManiSwiss 651.01 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Valera ManiSwiss 651.01 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info