655265
78
Zoom out
Zoom in
Previous page
1/116
Next page
For interactive manual scans, use the Real time display and the Antenna utility to have
interactive control and feedback. IRIS does not take a noise sample before running a manual
scan. For more information, see IRIS and RDA Utilities Guide.
1. Add the task to the schedule:
In most cases, use a manual scan task on an ad hoc basis.
To prevent the manual scan task from interfering with regularly scheduled tasks:
Set Stop to None so the scan can work at any time of day.
Set Repeat to None.
Set Mandatory to Non-mandatory, so it does not interfere with mandatory scans
such as a regularly scheduled volume scan.
Set Skip to Yes so that if it is preempted, it does not run.
Set State to Idle so it does not start automatically.
For information on
configuring a manual scan, see 8.2. Antenna and Radar Control
(page 49).
2. To run the scan, select one of the following:
TSC Monitor > Go Schedule
TSC Monitor > Go ASAP
Go Schedule and Go ASAP delay the start of the task according to the Repeat settings.
If Repeat is set to None, the commands have the same
eect.
3. If the TASK configuration is set to Continuous, stop the task with the Halt command.
In most cases, set the task configuration to Continuous, especially for interactive scans
with the real time display and the Antenna utility.
If the task
configuration is set to Non-Continuous, the task stops automatically after it
has collected the prescribed number of data rays (up to 720).
9.9. Running A Task
1. In the TSC Monitor menu, select, the task you want to run.
2. Place the cursor over Command and select either:
Go (Schedule)
Runs the task according to schedule.
The task status changes from Idle to either Scheduled or Running.
Go (ASAP)
Runs the task immediately, depending on the priority of other tasks. Use this for
interactive operation
The status changes to ASAP, indicating that the task is scheduled to run as soon as
possible. The task runs once, and then the status changes to Scheduled and is
added to the schedule.
9.10. Stopping a Task
1. In the TSC Monitor menu, select the task you want to stop.
IRIS User Guide M211317EN-E
76
78


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaisala IRIS Radar at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaisala IRIS Radar in the language / languages: English as an attachment in your email.

The manual is 5,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info