665293
10
Zoom out
Zoom in
Previous page
1/56
Next page
Installation
10 Installation instructions VRC 470f 0020124645_00
4
> If necessary, open the front cover on the boiler.
> Carefully lever the blind cover from the control cabi-
net.
> Carefully lever the radio receiver unit from the wall-
mounting base (¬Section4.4.1).
> Check which type of switch box the boiler has:.
1
2
Fig.4.1 Plugging in/removing pin header connector
If there are vertical plug connections with pins:
> If the 3-pin pin header connector (2) is pre-fitted on
the PCB (1) of the radio receiver unit, then remove it.
> Carefully press the radio receiver unit into the con-
nection in the switch box.
If there are horizontal plug connections without pins on
the control cabinet:
> If the 3-pin pin header connector (2) is not pre-fitted,
plug the short pins of the 3-pin pin header connector
supplied with the controller into the horizontal row of
3holes on the PCB (1) of the radio receiver unit.
> Carefully press the radio receiver unit with the pin
header connector into the connection in the switch
box.
> If you have not already done so, install the outside
temperature sensor/transmitter (¬Section4.5).
> Switch on the power supply to the boiler.
> Bring the boiler into operation.
> If necessary, close the front cover of the boiler.
4.4 Wall-mounting the radio receiver unit
i
Wall-mounting the radio receiver unit is only
necessary if its position needs to be optimised
after start-up in order to ensure good radio
communication with the controller and the
outside temperature sensor/transmitter.
3
4
4
7
6
5
3
2
1
3
Fig.4.2 Mounting the radio receiver unit
1 Radio receiver unit
2 Wall-mounting base
3 Mounting holes
4 Openings for cable entry
5 Pin header with terminals for the eBUS cable
6 Wall-mounting base cover
7 Slot for screwdriver
4.4.1 Removing the radio receiver unit from the
wall-mounting base
> Insert a screwdriver into the slot (7) on the wall-
mounting base (2).
> Carefully lever the radio receiver unit (1) off the wall-
mounting base (2).
10


Need help? Post your question in this forum.

Forumrules
1

Forum

vaillant-vrc-470f

Reset search

  • How can one test if a VR20 outside temp. sensor is working? If pressing the Red button on the rear of the module does not activate the flashing green light. is this an indication of faulty unit? The lens is clean. Solar sensor charging at around 2.1 volts. Battery is at 3volts. Submitted on 29-12-2021 at 16:45

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaillant VRC 470F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaillant VRC 470F in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info