602543
25
Zoom out
Zoom in
Previous page
1/52
Next page
Maintenance 7
0020147164_04 aroTHERM Installation instructions 25
6.12.3.1 Heat pump setting parameters
To individually set the heat pump, you can adjust certain
parameters in the Configuration menu.
Menu Installer level Configuration
Additional setting data is listed in the appendix.
Heat pump setting parameters ( Page 44)
6.13 Installing the side cladding
C
C
B
A
Install the side cladding.
6.14 Instructing the operator
1. Explain the how the system operates to the operator.
2. Draw particular attention to the safety information,
which the operator must follow.
3. Make the operator aware of the need for regular main-
tenance (maintenance contract).
4. Explain to the operator how to check the system's water
volume/filling pressure.
7 Maintenance
7.1 Observing maintenance intervals
1. Only carry out maintenance work if you are a competent
person.
2. Carry out annual maintenance.
7.2 Preparing for maintenance
7.2.1 Procuring spare parts
The original components of the unit were also certified as
part of the CE declaration of conformity. Information about
available Vaillant genuine spare parts is available by con-
tacting the contact address provided on the reverse of this
document.
If you require spare parts for maintenance or repair work,
use only Vaillant genuine spare parts.
7.3 Instructions before carrying out
maintenance work
Observe the basic safety rules before carrying out mainten-
ance work or installing spare parts.
Danger!
Risk of injury due to unauthorised access
to the coolant circuit.
Escaping coolant may cause freezing if the
exit point is touched.
Only carry out work on the coolant circuit if
you have been trained to do so and if you
have the required protective clothing.
Avoid skin and eye contact with the
coolant.
Switch the system off.
Disconnect the system from the power supply.
Where necessary, disconnect the heating circuit from the
product by using the stop valves.
If you have to replace parts on the heating circuit, you
must first drain the product.
When working on the product, protect all electric com-
ponents from spray water.
7.4 Yearly maintenance
Check that the safety devices are functioning properly.
Check the heating circuit's fill pressure.
Ensure that there are no traces of rust or oil on the
coolant circuit components.
Ensure that the product components are neither worn nor
defective.
Check that all wires sit securely in the connectors.
Check the product's earthing.
Check the heating pump's flow temperature and the set-
tings.
Remove any dust from the electronics box and the in-
verter box.
Clean the ribbed pipe heat exchanger and ensure that air
circulates between the fins and around the product.
Check that the fan rotates freely.
Check that condensate can escape freely from the heat
pump by removing the adaptor underneath the heat
pump.
Clean the product as described in the operating instruc-
tions.
Check that the vibration dampers are correctly seated on
the coolant lines.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaillant aroTHERM VWL 155-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaillant aroTHERM VWL 155-2 in the language / languages: English as an attachment in your email.

The manual is 3,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vaillant aroTHERM VWL 155-2

Vaillant aroTHERM VWL 155-2 User Manual - German - 24 pages

Vaillant aroTHERM VWL 155-2 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info